Installation instructions in-line blower models: ilhsf8, ilhsf10 part no. 103719 rev. E suitable for use in a household cooking area. Suitable for use with solid state controls. To complete this blower, the hood assembly must be purchased separately. See the hood installation instructions to determi...
Installation instructions .................................................... 5 installation preparation .................................................... 5 installation ........................................................................ 5 verifying proper operation ...........................
1 important information about safety instructions the • important safety instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or oper- ating this or any other appliance. A...
2 important safety instructions do not install or operate this unit if it has been dam- • aged, dropped, has damaged electrical wiring or is not working properly. If the product is damaged when received, immediately contact the dealer or builder. Use this blower only for its intended purpose as out-...
3 product dimensions product specifications 3/16” (0.5 cm) (16.5 cm) 6 ½" (33.6 cm) 13 ¼" (33.0 cm) air flow 13” (20.3 cm) (20.8 cm) 8” ref 8 3/16” (5.7 cm) 2 1/4” (20.3 cm) 8” ref (33.0 cm) 13” (15.2 cm) 6” (41.9 cm) 16 ½" 3/16” (0.5 cm) 15 1/4” (38.7 cm) 19” (48.3 cm) 16” (40.6 cm) 8 1/4” (21.0 cm...
4 installation planning system layout warning to avoid the risk of fire due to the unit overheating: do not • install this blower with a hood or raised vent that has an internal blower. Do not • install more than one blower to increase the length of the duct run. Even small differences between blowe...
5 installation preparation verify package contents blower assembly • parts required four (4) #10 x ¾”, round head screws (suitable for the • material the blower will be mounted to) 1/2” 3 wire conduit with a 1/2” ul certified strain relief • on each end (length is determined by in-line blower locati...
6 grn l1 blu blk gnd n1 install the duct work according to the installation 13. Instructions for the hood or raised vent. Support the duct weight as necessary to ensure properly sealed joints. Verifying proper operation warning read the raised vent or hood use and care manual completely before opera...
7 technical data blower ratings wiring diagram model number nominal rating* actual rating* ilhsf8 600 cfm 650.7 cfm ilhsf10 1100 cfm 1115.9 cfm * at zero inches static pressure airflow cfm (cubic feet/minute) static pressure - inches of water 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 200 400 600 800 1000 1200 i...
8 notes.
Dacor ● phone: (800) 793-0093 ● fax: (626) 403-3130 ● www.Dacor.Com.
