I n s ta l l at i o n i n s t r u c t i o n s part no. 101589 rev. C m i c r o wav e i n -a-d r aw e r ™ for use with models: mmdv30s mmd30s mmd30b tinseb448mrr1.
T able of c ontents appliance safety ..........................................................................1 installation recommendations ...................................................1 important notes to the installer ................................................1 important notes to the...
Warnings if the information in this manual is not followed exactly, a fire or electrical shock may result that could cause property damage, personal injury or death. To reduce the risk of tipping, the microwave in-a-drawer™ must be secured by a properly installed anti-tip block. • this drawer must b...
D esign s pecifications • dimensions that are shown in figures 2 and 3 must be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. • contact surface must be solid and level. Pay special attention to the floor on w...
Note: open top cabinet illustrated a. 6" b. Electrical outlet location c. Anti-tip block d. 5" e. 3 1/2" f. 4" g. 28 7/16" opening k. Allow 1/4" overlap h. 14 3/4" to bottom of anti-tip block i. Allow 3/4" overlap j. 23 1/2" minimum depth q. 15 3/16" ± 1/16" opening l. 36" countertop height m. Allow...
The electrical requirements are a 120 volt 60 hz, ac only, 15 amp. Or more protected electrical supply. It is recommended that a separate circuit serving only this appliance be provided. The drawer is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly ...
The information and images in this book are the copyright property of distinctive appliances, inc. Neither this book nor any information or images contained herein may be copied or used in whole or in part without the express written permission of distinctive appliances, inc. © 2006 distinctive appl...
