Dacor Millennia ETT304-1 Planning Manual - Ett304-1 And Ett365-2
PLANNING
GUIDE
3.5
Specifications subject to change without notice.
Phone: (800) 793-0093
www.dacor.com
30 Inch and 36 Inch Wide,
Renaissance
®
Electric Cooktops
Ett304-1 and Ett365-2
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
Document # PG03-002
Revised 10/01/11 Page 2/3
When installing model ETT365-2 and the bottom of the chassis is to be enclosed
wall to wall, you must install Dacor ventilation duct kit ATD323.
Allow a minimum of 6 inches (15.2 cm) clearance between
the top of the countertop and any combustible surface
below, including the upper edge of a drawer below the
cooktop. Proper under-cabinet clearance is also required
for the cooktop hold down brackets.
6” (15.2 cm)
min. clearance
to combustible
surfaces
A
6" (15.2 cm) min.
from mounting surface to
combustibles below
cooktop chassis
B
min. to combustible,
side wall, both sides
Rear
wall
1" min.
19 3/4" min.
(50.2 cm)
6" (15.2 cm)
(2.5 cm)
2 1/4" min.
(5.7 cm)
UNDER CoUNtER CLEARANCE
Model
(A) Minimum Under Counter
Clearance (Width)
ETT304-1
30 1/2” (77.5 cm)
ETT365-2
36 1/2” (92.7 cm)
Model
(B) Minimum Under Counter
Clearance (Width)
ETT304-1
28 3/4” (73.0 cm)
ETT365-2
34 3/4” (88.3 cm)
CoUNtERtoP CUtoUt (WIthoUt RAIsED vENt)
3/4”
7 3/4” X 4 3/8
” ventilation cut-outs in enclosure floor
1 1/2”
1 1/2”
3/4”
toP vIEW vENtILAtIoN CUtoUt
Cooktop cutout in
top of cabinet