Installation instructions glass wall mount range hood phw model series part no. 101745 rev. F.
Installation instructions ............................................... 5 verify the package contents ....................................... 5 installing the chimney mounting bracket ................... 6 installing the duct work .............................................. 7 hanging the blower...
1 important information about safety instructions • the important safety instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. • a...
2 important safety instructions • do not install or operate this hood if it has been damaged, dropped, has damaged electrical wires or is not work- ing properly. If the product is damaged when received, immediately contact the dealer or builder. • the customer should not install, repair or replace a...
3 planning the location • carefully check the location where the hood is to be installed. The hood should be placed for convenient access. Make certain that electrical power can be provided in the selected location. • plan the installation so that all minimum dimensions shown are met or exceeded. Di...
4 electrical specifications warning the electrical service to the range hood should be installed only by a licensed electrician. It is the owner’s responsibility to ensure that the electrical connection of this appliance is performed by a qualified electrician. The electrical installation, including...
5 installation instructions unpack the box and verify that all parts listed have been provided. If any item is missing or damaged, please con- tact the dealer immediately. Do not install a damaged or incomplete appliance. Make sure you have everything required for proper installation before proceedi...
6 installing the chimney mounting bracket 1. Determine the vertical center line for the range hood. The center line for the hood is usually the same as the center line of the range or cooktop. 2. Using a pencil, mark the vertical center line on the wall from where the bottom of hood will be located ...
7 installing the duct work important - the installed duct work must: • be centered on the vertical center line drawn on the •wall. • fit flush into the half circle on the chimney mount- ing•bracket,iftheductworkistoenterthechimney through the ceiling rather than through the back wall). • extend down...
8 3. Insert two provided machine screws into the two holes above the mounting bracket on the blower assembly and tighten into place. 4. Insert two machine screws through the front of the mounting bracket and tighten into place. 5. Insert two machine screws through the side of both “l” brackets and t...
9 installing the chimney important: be careful not to pinch the electrical wires while installing the chimney. 1. Remove the protective plastic covering from both pieces of the chimney assembly. Do not remove the protective tape strips from the inside of the chimney. They protect the telescoping pie...
10 installation instructions installing the glass hood warning attaching the glass range hood requires two people. Do not attempt to lift the hood without assistance. 1. Locate the hood mounting hardware. It consists of: ◊ 4 thumb screws ◊ 4 plastic washers ◊ 4 plastic spacers 2. For easier hood ins...
11 installation instructions installation checklist warning • to ensure a safe and proper installation, the follow- ing checklist should be completed by the installer to ensure that no part of the installation has been overlooked. • proper installation is the responsibility of the home- owner. The i...
12 notes.
Dacor●600antonblvd.Suite1000costamesa,ca92626●phone:(800)793-0093●fax:(626)403-3130●www.Dacor.Com.
