Dacor Preference SGM304 Installation Instructions Manual - page 10
8
Turn on the gas supply valve.
5.
Perform the following ignition test for all of the burners:
6.
Press and turn the control knob
◊
slowly
counterclockwise to the HIGH position. All burner
igniters will spark. It may take up to four seconds
for the burner being turned on to ignite, at which
time the igniters will stop sparking. If ignition does
not occur within four seconds, turn off the knob,
wait for at least two minutes to allow any gas to
dissipate, then repeat the test.
Once the burner lights, the control knob can be
◊
rotated counterclockwise from
HIGH to LOW to
adjust the flame height progressively.
When the unit is installed properly, the flame will
◊
be steady. It will also have a sharp, blue inner
cone that will vary in length proportional to the
burner size. The flame will be reduced by the Smart
Flame™ feature under the grate fingers to increase
grate life.
NOTE: If the cooktop does not operate properly, follow
these troubleshooting steps:
Verify that power and gas are supplied to the cooktop.
•
Check to make sure that the power plug is connected
•
to the electrical outlet and that power is turned on at
the circuit breaker or fuse box.
Check to make sure that the burners are properly
•
seated.
If the burner continues to spark after ignition without
•
stopping, have a licensed electrician check the
electrical outlet for proper grounding or reversed
polarity.
Repeat the above burner ignition test.
•
If the appliance still does not work, do not attempt
•
to repair the appliance yourself. Contact the Dacor
Customer Service Team at (800) 793-0093.
I
nstallatIon
I
nstructIons
Verifying Proper Operation
WARNING
Make sure that power to the electrical outlet is
•
turned off at the circuit breaker or fuse box and that
the gas is turned off at the gas supply valve before
proceeding.
The cooktop must be properly grounded at all times
•
when electrical power is applied.
Prior to operating the cooktop, read the accompanying use
and care manual carefully.
Make sure all the cooktop burner controls are in the
1.
OFF position.
Connect the power cord to the electrical outlet.
2.
Turn on power to the electrical outlet at the circuit
3.
breaker or fuse box.
Depress and turn one burner control knob at a time
4.
slowly counterclockwise to the HIGH position. Verify
that all the burner igniters spark, then return the knob
to the OFF position. Repeat for all of the remaining
control knobs.
Normal Flame Appearance
Off Position
Knob Position
Indicator
(Polished Surface)
Burner
Designation
Light & High
Position
Area of
Operation
Low
Position
Logo on Front
Knob Only
SGM Burner Control Valve