Dacor Renaissance RNCT365G Installation Instructions Manual

Other manuals for Renaissance RNCT365G: Use And Care Manual

Summary of Renaissance RNCT365G

  • Page 1

    Installation instructions renaissance ® series gas cooktop models rnct305g, rnct365g part no. 109327 rev. A.

  • Page 2

    Downdraft compatibility ...............................................6 verifying the package contents ...................................8 installing the cooktop ...................................................8 connecting the gas line..............................................8 assembling t...

  • Page 3

    1 important information about safety instructions • the important safety instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or oper- ating this or any other appliance. •...

  • Page 4

    2 important safety instructions • read the accompanying use and care manual com- pletely before operating this appliance. • keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • if you receive a damaged product, immediately con- tact your dealer or builder. Do...

  • Page 5

    3 electrical requirements warning to prevent an electric shock hazard, the power supply must meet the specifications stated below. It is the own- er’s responsibility to make sure that the electrical service meets electrical requirements and that the electrical outlet has been properly installed by a...

  • Page 6

    4 installation specifications warning observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Product dimensions front of unit power cord 42” (106.7 cm) long 1/2” male npt gas inlet 2” (5.1 cm) 1 3/4” (4.4 cm) 1/2” ...

  • Page 7

    5 installation specifications rnct305g and rnct365g surface vs chassis overhang dimensions a 2" (5.1 cm) from countertop to cooking surface 21" (53.3 cm) 4" (10.2 cm) chassis height model a (width) b (width) rnct305g 30” (76.2 cm) 27 5/16” (69.4 cm) rnct365g 36” (91.4 cm) 33 5/16” (84.6 cm) side vie...

  • Page 8

    6 cabinet and countertop layout warning • to reduce the risk of personal injury caused by reaching over a hot appliance, avoid locating cabinet storage space directly above the cooktop. • failure to meet or exceed the maximum and mini- mum dimensions/clearances stated in these instruc- tions may res...

  • Page 9

    7 installation specifications cutout dimensions cooktop with downdraft: erv series countertop cutout dimensions all tolerances +1/16” -0” (+1.6 mm) unless otherwise noted. Countertop cutout view 4 1/4” (10.8 cm) min. From mounting surface to combustibles below cooktop chassis e f c d minimum distanc...

  • Page 10

    8 verifying the package contents • hold-down brackets (2) • grates: (3) • burner sets: (5) • gas pressure regulator: (1) • stainless steel cleaner: (1) (stainless steel models only) if any parts are missing, please refer to the customer service information section on the inside cover. Installing the...

  • Page 11

    9 installation instructions assembling the burners warning • never attempt to operate the cooktop with any of the burner parts removed. • do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. 1. Remove the burner heads, burner rings, burner caps, and gr...

  • Page 12

    10 installation instructions important: assemble the grates as instructed below. When installed correctly, the openings in the grates are centered over the burners. 1. Locate the notch on the bottom of each grate. 2. Use the notch on the bottom of each grate to determine where the grate is placed an...

  • Page 13

    11 installation instructions verifying the correct setup warning • make sure that power to the electrical outlet is turned off at the circuit breaker panel or fuse box and that the gas is turned off at the gas supply valve before proceeding. • the cooktop must be properly grounded at all times when ...

  • Page 14

    10 installation instructions installation checklist warning to ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. The importanc...

  • Page 15

    11 wiring diagrams warning label all wires prior to disconnection when servicing controls. Miswiring can cause malfunction and dangerous operation. Verify that the unit is working correctly after servicing. 120 vac, 60 hz. Power pupply wiring diagram: rnct305g rnct365g.

  • Page 16

    Dacor ● 14425 clark avenue, city of industry, ca 91745 ● phone: (800) 793-0093 ● fax: (626) 403-3130 ● www.Dacor.Com.