Installation instructions induction cooktop models: rnct304 and rnct365 part no. 107240 rev. C.
Cabinet layout ................................................................. 4 cabinet cutout dimensions ............................................. 5 installation instructions .................................................... 7 verify the package contents .....................................
1 important information about safety instructions • the important safety instructions and warnings in this manual are not meant to cover all possible prob- lems and conditions that can occur. Use common sense and caution when installing, maintaining or oper- ating this or any other appliance. • alwa...
2 important safety instructions • read the accompanying use and care manual before operating this appliance. • keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • if you receive a damaged product, immediately con- tact your dealer or builder. Do not install ...
3 installation specifications product dimensions 36” (91.4 cm) 2 34” (86.4 cm) 1 19” (48.3 cm) 1 21” (53.3 cm) 2 3/16” (4.8 mm) glass thickness: 3 7/8” (9.8 cm) 30” (76.2 cm) 2 28” (72.4 cm) 1 19” (48.3 cm) 1 21” (53.3 cm) 2 3 7/8” (9.8 cm) 3/16” (4.8 mm) glass thickness: important this appliance is...
4 cabinet layout under counter clearance important: to allow for ventilation, maintain a minimum of 5 3/4” (14.6 cm) clearance between the top of the coun- ter and any surface below, including the upper edge of any drawers below. Also maintain a clearance of 2” (5.1 cm) between the vents on the fron...
5 cabinet cutout dimensions cabinet clearances model a b rnct304 30” (76.2 cm) 28 3/4” (73.0 cm) rnct365 36” (91.4 cm) 34 3/4” (88.3 cm) installation specifications all tolerances: +1/16 (+1.6 mm), -0, unless otherwise stated. 1 30 inches minimum clearance between the top of the cooking surface and ...
6 installation specifications 21 1/8” (53.7 cm) countertop inset (side view) countertop 19 3/4” (50.2 cm) 3/16” (4.8 mm) 11/16” (7.0 mm) a b 19 3/4" (50.2 cm) cabinet face c d e f g cabinet cutout dimensions (cont.) all tolerances: +1/16 (+1.6 mm), -0, unless otherwise stated. Important: see previou...
7 installation instructions 3. Secure the cooktop to the countertop using the two (2) hold-down brackets provided. Slide the brackets into the slots located on the left and right sides of the chassis, then tighten the screws to the underside of the countertop. Do not overtighten. Electrical connecti...
8 three wire connection with external ground conduit to cooktop incoming power wire nut, 3 places junction box separate 10 awg wire minimum clamp wire tightly to cold water pipe three wire electrical connection important: no white wire connection is required for this 3-wire appliance. If there is an...
9 installation instructions verifying proper operation warning read the accompanying use and care manual completely before using the cooktop. 1. Remove all items from the cooktop. Remove any tape that may be attached to the cooktop. 2. Clean the cooking surface according to the use and care manual p...
Dacor ● 14425 clark avenue, city of industry, ca 91745 ● phone: (800) 793-0093 ● fax: (626) 403-3130 ● www.Dacor.Com.
