Dacor RV30 Installation Instructions Manual - page 8
7
Cooktop Installation
Set the cooktop into the countertop opening so
that the back edge of the cooktop overlaps the
leading edge of the vent. (Refer back to page 4.)
Follow the cooktop manufacturer’s installation
instructions regarding securing the cooktop to
the countertop and completing the electrical
and/or gas connection.
NOTE:
Do not use a hardening
compound or caulking to
permanently seal the cooktop and
vent into place, as the units must
be easily removed for service. If
such a hardening compound is
used, removal of the units will be
at the customer’s expense.
Verifying Operation
Please read the accompanying Use & Care
Manual carefully. Important safety, service and
warranty information is contained within this
manual.
WARNINGS:
1. If the vent system is not
operational after completion of
the installation, do not attempt
to repair it. See the Problem
Solving section of the Use
& Care Manual, then call a
qualified service technician if
the
system is still not functional.
2. Always disconnect the
appliances from the electrical
power when servicing them.
3. Install the two (2) grease filters
and the grill prior to operating
the vent. Refer to the Use
& Care Manual for instructions
regarding filter and grill
installation.
4. Ensure that the top cap on
the vent intake does not
catch on the back edge of the
cooktop when the intake is
lowered. If interference does
occur, adjust the position
of the cooktop by moving
it against the front edge of
the countertop cutout, then
re-secure the cooktop to the
countertop. Also, ensure that
the vent support legs have
been properly secured to the
cabinet base using the screws
provided in the instructions
envelope. Failure to eliminate
interference may result in
permanent damage to the
vent.