Daewoo DDWMJ1411W Operating Instructions Manual - Starting The Programmes
Starting the programmes
Turning on the appliance
•
Starting the cycle
1. Draw out the lower and upper basket, load the dishes and push them back.
It is recommended to load the lower basket first , then the upper one( see the section entiltled “Loading the
dishwasher racks”)
2. Pour in the detergent or add the dishwasher tablet on the dispenser.
3. Insert the plug the socket. The power supply is 220-240V~, 50 Hz, the specification of the socket is 10A 250VAC.
Make sure that the water supply is turned on to proper pressure.
4. Close the door and press the Power button , to switch on the machine.
5. Press the (program) button, the wash program will be changed as follows:
ECO-> Glass -> 90 Min -> Rapid -> Intensive -> Normal -> ECO
If a wash program is selected, the response light will be on. Press the Start button, the dishwasher begins
to start.
*
When you press the START
button to pause during the cycle, the running indicator will stop blinking and the
dishwasher will beep every minute unless you press the START
button to re-start again.
•
Change the program
Premise :
1. a cycle that is underway can only be modified if ithas only been running for less than 2 minutes. Otherwise, the
detergent may have already been released , and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled.
2.
Then,
press (pause) button -> press (program) button more than 3 seconds to cancel the running cycle->
Select the new program-> Press start button again.
*The programme should not be changed if it has been running more than 2 minutes .
We do not recommend to change the cycle once Start button has been pressed.
• At the
End of the wash cycle
1. Switch off the dishwasher by pressing POWER button.
2. Unloading the dishes and cutlery. (please see the below attention before unloading)
It is normal that the dishwasher is wet inside. Empty the lower basket first and then upper one. This will avoid
water dripping from the upper basket onto the dishes in the lower one.
3. Close the door.
When the working cycle has finished, the buzzer of dishwasher will beep shortly, then stop. in the digital display
appearsn “0” , only in this case the programme has ended.
Attention_ before unloading!!
• Open the door carefully. Hot steam may escape when the door is opened.
•
Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around 15 minutes before removing from the
appliance.
• Open the dishwasher’s door, leave it and wait a few minutes before removing dishes. In this way they will be cooler and the
drying will be improved.
• Finally unloading the dishwasher
14