H w a a n l g l e r u n i t plasma monitor (display) wall hanger unit instruction manual dp-hg22 thank you for purchasing the daewoo electronic plasma display wall hanger unit. This wall unit is specifically designed for use with the daewoo plasma display. To ensure the safe operation of the unit, p...
1 table of contents 1. Check for enclosed parts .............................. 2 2. Important safety instructions ........................ 3 3. Assembly instructions ................................... 6 4. Adjusting angles after installation ................12 * to install the wall hanger unit, ple...
Plasma display hanger unit 2 h w a a n l g l e r u n i t 1. Please check the items shown below (2) frame set a frame set b connecting frame concrete wall anchor m5 screws (20 mm) wall screws paper pattern plan m5 screws (30mm) (2) (1) (8) (12) (8) (1) (2) paper pattern plan.
3 2. Important safety instructions warning : disregarding these instructions can result in serious injury. Caution : disregarding these instructions will result in the mistreatment of the unit and can result in injury or damage to the unit. Please keep these instructions for your safety and to preve...
Plasma display hanger unit 4 h w a a n l g l e r u n i t special care is needed when installing onto the wall due to its weight (35kg) when installing on a concrete wall please be sure to use the enclosed concrete anchors. When installing on a wooden wall take special care as the unit may require ex...
5 it is important to use the paper pattern plan to choose the proper place; otherwise, it can result in damage to the wall and you will not be able to install the unit if proper spacing is not allowed, it may cause the plasma display to overheat, which can cause fire or damage to the unit when insta...
Plasma display hanger unit 6 h w a a n l g l e r u n i t 3. Assembling instructions preparation when the plasma display is attached to the stand to detach the stand from the plasma display to place the protective caps . To avoid unwanted marks on the unit, place a protective covering over the surfac...
7 installing the wall frame set a on the plasma display panel how to install frame set a on the unit . To avoid unwanted marks on the unit, place a protective covering over the surface you will be working on and lay the plasma display as shown in the picture below. . When securing frame set a to the...
Plasma display hanger unit 8 h w a a n l g l e r u n i t installing wall frame set b and connecting frame installing wall frame set b and connecting frame. Attaching paper pattern plan on the wall . Place frame set b on the left and right side of the unit and use the enclosed screws (m5) to secure t...
9 install the wall frame set on the wall . Install the wall frame set on the wall by matching the concrete anchors with the holes, then use the wall screws (8) to secure tightly. Paper pattern plan 3 installing on the wall held by supporting wooden structure . If it is not feasible to attach frame s...
Connecting upper part of frame set a and frame set b . Insert the upper part of frame set a (x) to frame set b (y) as indicated below. * at least two people are needed to put these frames together. (x) (y) (z) frame set b frame set a 1 plasma display hanger unit 10 h w a a n l g l e r u n i t connec...
11 to provide the securest fit . After installing plasma display and wall frame sets, for a more secure fit, secure m5 screws (m5x30) on the (z) part so that (z) will not move up and down as shown in the picture below. 3.
Plasma display hanger unit 12 h w a a n l g l e r u n i t 4. Adjusting angles after installation (10˚, 15˚, 20˚) how to adjust viewing angles the figures below display the possible plasma display angles. . Take out the screws from the upper part of the frame. . Insert the upper part of the frame set...
