Daewoo DSI-9100 Instruction Manual - Vcr F
➠ 37
Video Recorder+Satellite Receiver
11
➠ 36
Video Recorder+Satellite Receiver
VCR F
RONT
P
ANEL
I
NDICATIONS
The six small icons on the left and right of the front panel indicate the following:
Tape inserted. Flashes as a tape is being ejected or if there is no tape or a write-
protected tape inserted when a recording begins.
VCR mode (when lit)or TV mode (when unlit).
Timer recording(s) programmed. Flashes if a timer recording cannot start because the
VCR is not in Standby.
Long Play mode (when lit) or Short Play mode (when unlit). During tape playback this
shows the speed of the recording on tape. During recording this shows the speed of
the recording. At other times this shows the speed selected for the next OTR.
Recording in progress.
The following will also appear on the front panel:
---- VCR is starting up. Please wait.
--:-- VCR ready for use. Please press [
] on the remote control to start.
Clock VCR is in Standby and showing the current time. The display is dimmed to save
power.
STOP The tape has stopped.
EJCT The tape is ejecting.
PLAY The tape is playing. Flashes when auto-tracking is happening.
STILL The tape is playing and in Pause (freeze frame) mode.
SLOW The tape is playing and in slow-motion mode.
SCH The tape is playing fast-forwards.
SCH- The tape is playing backwards.
IND+ The tape is searching forwards for the next recording.
IND- The tape is searching backwards for the previous recording.
REC Recording in progress
RECP One-Touch Recording paused.
OTR Countdown One-Touch Recording time remaining in hours and minutes or minutes
and seconds.
ERR A tape or VCR mechanism fault has been detected. See the Troubleshooting Guide
for more help.
When you press any remote control button,you will see the a dot blink briefl that the VCR has
seen the remote control command.
11
T
APE INFORMATION DISPLAY