Daewoo FF258HW User Manual - page 7
7 |
P a g e
6. Power supply
• Check your local power source. This appliance requires a current of
approximately 0.45A(input), 240V 50Hz.
• Power supply cord is about 1.7 meters long.
• The voltage used must be the same as specified on this appliance. Using
a higher voltage may result in a fire or other accident causing oven
damage. Using low voltage will cause failure of operation. We are not
responsible for damage resulting from use of this appliance with a voltage
of ampere fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a
hazard.
LEVELING
If the front of the appliances slightly higher than the rear, the door can be
opened and closed more easily.
1. The appliance tilts down to the left.
Turn the left adjusting leg in the
direction of the arrow until the
appliance is lever.
2. The appliance tilts down to the right.
Turn the right adjusting leg in the
direction of the arrow until the
appliance is lever.
Service Helpline Centre
Before contacting our Customer helpline:
1. Try to remedy the problem (please read section “troubleshooting
guide”).
2.
Restart the appliance to check whether the fault repeats. If the
malfunction persists, switch off the appliance and try again after
an hour.
3. If the malfunction still persists, then contact our Customer Service,
specifying:
- Model number: (FF258HW)
- Serial number(S/N) of the appliance: it could be at the back of
appliance.
- Your full address, telephone number and area code.
TROUBLE SHOOTING GUIDE
1. The appliance does not operate. Please Check:
- Power failure/cut,
- Power plug may be unplugged,
- Circuit breaker has tripped,
- Damage to the mains lead,
- correct setting of the temperature controls.
2. The temperature inside the compartments is not low enough, Check
for:
- Temperature control not set on proper position
- Door openings,
- Installation near a heat source,
- inhibited air circulation.