Daewoo FR-4906S Manual
1
•
Unstable installation causes vibration and
noise of refrigerator.
•
Wooden floor or carpet can be discolored
under the refrigerator.
•
Doors look hanged down due to the twist
of refrigerator unless it is leveled.
•
More than 6 or 10 cm from 3 sides (left,
right and back) is good enough for
v e n t i l a t i o n .
•
Insufficient space causes the noise of
vibration, weakening of refrigerating
power and the waste of electricity.
•
Direct sun lays, side heat of stove and gas
range can weaken the refrigerating power.
•
Avoid location by a sink or where moisture
and water can cause rust and corrosion.
•
Avoid location where moisture can cause
electrical problems.
•
Use hard board or plank on the
concrete/cement floor.
1. Installation Instructions
Where the floor is solid and level
Where ventilation is good
Where there is little or no heat, moisture
S u i t a ble Installation Place
Grounding is necessary
w h e r e
Grounding by using
grounding wire
Grounding by using
short-circuit breaker
Grounding is not necessary
You should not connect the
ground wire to
■
Grounding terminal is the yellow/green one connected to the power cord in the back of refrigerator.
Bury copper plate to whitch grounding wire is connected 25 cm deep in the ground.
Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
restaurant kitchen etc.
in case of using side-grounded outlet.
water pipe, gas pipe, telephone line,
l i g h t e n i n g - r o d .
There can be explosion or fire.
Grounding wire
S i d e
G r o u n d e d
o u t l e t
G ro u n d i n g
Correct usage of Refrige r a t o r
water can splash easily ;
bathroom etc.
there is much moisture ;
basement etc.
any wet and/or watery
p l a c e s .
Plug in the refrigerator right
after installation.
Set the fresh food compartment’
temperature to “7” to perform
preparatory run for 2 or 3 hours.
When the inside is cold enough,
put the foods in.
* See page
f o r d e t a i l s .
* When the surrounding temperature is hot in midsummer, do not open and shut the
doors too often after installation.