Wireless 11n projector server quick installation guide dn-70300
Thank you for purchasing this wireless projector server! Before you start to use this projector server, please check if any item in the packing is missing. Packaging list item name qty. Wireless projector server 1 a/c adapter 1 network cable 1 remote controller 1 rubber foot pad 4 wireless antenna 2...
Setup wireless projector server please follow following steps to setup projector server stick the foot pads on the 4 locations indicated on the picture shown below if you plan to put the projector server on the desk or other horizontal places. You can skip this step if you plan to hang the projector...
Insert audio cable into audio-out connector, and connect another end of cable to your projector’s audio-in connector or audio amplifier. You can skip this step if your projector doesn’t have audio-in connector, or you don’t plan to use audio. Insert video cable into video-out connector, and connect ...
Press ‘power’ button, and ‘power’ led on projector server will light after few seconds, which indicates projector server is switched on. Projector server will acquire an ip address from the dhcp server on your lan automatically, and the ip address will be displayed at the bottom-left corner of the d...
Click ‘run’ when you see this message. Click ‘run’ to start utility installation procedure. If you see this message, click ‘unblock’. (you must click ‘unblock’ or client utility will become unusable)..
Client utility will look for any available projector servers on your network. If you have more than one projector server, select one from ‘server ip’ dropdown menu, then: 1) input a user name in ‘login name’ field, so you can identify yourself among others. It will use your computer’s name by defaul...
Click to start presentation. The display content of your computer will be displayed on projector / monitor. Click ‘1’, ‘2’, ‘3’, or ‘4’ to display at a specific display area (see user manual for detailed instruction). To stop presentation, click ‘ ’ button..
