Digizoid ZO User Manual - Warnings

Other manuals for ZO: Product Manual, Smart Start Manual

Page of 4

Download

Bookmark us

Warnings

Adjust the volume of the audio source to a safe level before putting

on headphones or earphones.

Even though SmartVektor technology optimizes audio signals to the ear’s

sensitivity, potential hearing damage may occur if listening at high volume

levels from your audio source for extended periods. If you experience

ringing in your ears, reduce the volume level of your audio source to

prevent permanent damage.

Do not connect ZO to a mono channeled system.

Do not use ZO in a double-ampliﬁcation conﬁguration (i.e., do not use ZO

with another headphone ampliﬁer).

If your ZO does not turn on, ensure...

the battery is charged.

If no sound is heard or the audio is distorted, ensure the...

connections are correct;

cables are not damaged;

cables are fully inserted into the jacks (a faint snap should be heard);

audio source is playing and the volume levels are above the minimum

settings;

audio source equalizer settings are properly neutralized.

If the battery does not charge, ensure...

a USB 2.0 port is being used;

your computer is turned on or out of sleep mode.

To obtain more information on our warranty policy, please visit

www.digiZoid.com/warranty. Also, do not make repairs to ZO yourself,

as this will void the warranty.

Rev. A - Online

digiZoid, SmartVektor and ZO are trademarks or registered trademarks of digZoid inc.

Page 1
Know your zo smartvektor ™ controller (svc) input jack output jack charge status indicator usb charging port lightscale display colored led displays the selected contour & volume levels, and secondary led blinks when battery is low 2 zo turns zo on/oﬀ, triggers standby mode, controls sound contourin...
Page 2: Connect Your
Connect your zo listening device to zo connect the stereo jack of the listening device to the output of your zo. Zo to audio source ensure the output from the audio source has a 3.5mm jack size. Using the stereo cable provided, connect the output of the audio source to the input jack of your zo. Lis...
Page 3: Control Your
Control your zo powering on/oﬀ to turn your zo on, push in & release the svc. When on, the lightscale indicator will illuminate. To turn your zo oﬀ, push in & hold the svc until the light goes oﬀ. Changing contour level with the svc when your zo is turned on for the ﬁrst time, the svc will be set at...
Page 4: Warnings
Warnings adjust the volume of the audio source to a safe level before putting on headphones or earphones. Even though smartvektor technology optimizes audio signals to the ear’s sensitivity, potential hearing damage may occur if listening at high volume levels from your audio source for extended per...