Important safeguards parts and accessories how to assemble charging technical specifications troubleshooting cleaning how to use 1. 2. 3. Please read the instructions and warranty information carefully before use and keep them handy for future reference. The appliance may only be operated in accorda...
Warning! The hazards or unsafe practices below could result in appliance damage, serious personal injury, or death. Important safeguards 01 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. This appliance is not intended for use by persons (including children) with reduced physical sensory or mental ca...
Important safeguards 01 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. Warning: do not use the filter when wet, make sure it is completely dry to avoid damaging the appliance. The plug must be removed from the socket outlet before cleaning or maintaining the appliance. Clean the...
2 11 14 3 10 4 5 9 6 7 8 13 12 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Floor brush floor brush position switch telescopic extension release button telescopic extension air inlet body dust tank release switch on / off switch 2-in-1 brush tool dust tank empty lever exhaust filter housing remova...
The cyclonic vacuum cleaner comes preassembled. If there are any hard to reach or narrow areas, then the telescopic extension is ideal. It will need to be attached to the air inlet (1), and the required cleaning attachment fitted to the end (2). Step 1: step 2: step 3: step 4: attach the telescopic ...
Power cable charging port step 1: step 2: note: warning: connect the mains power adapter to the charging port on the vacuum cleaner. Plug the mains power adapter into the mains power supply. A flashing red light will indicate that the battery is charging. On completion, the light will stop flashing ...
Step 1: step 2: step 3: step 4: note: fit the telescopic extension into the air inlet. Push the crevice / brush tool onto the end of the telescopic extension, or onto the end of the accessory attachment nozzle if the telescopic extension is not in use. Select which attachment is to be used by rotati...
Step 4: step 5: to empty the dust tank, release the hatch by pressing the lever down while holding it over a bin or rubbish bag. Shake the dust tank gently to remove any remaining dust. To close the dusk tank again, simply push the lid closed until it locks back into place. Step 6: replace the dust ...
1. 2. 3. 4. 5. The vacuum cleaner must be taken off charge before cleaning or maintaining. Wipe the external surface of the appliance with a soft, damp cloth and allow to dry thoroughly. Do not use any detergents or harsh cleaning agents to clean any parts of the appliance. Ensure that the filter is...
Step 3: shake off the exhaust filter until the majority of the dust has been removed, then wash under clean, warm water, and allow to dry thoroughly. Step 4: once the exhaust filter has dried fully, slot it back into the filter housing, then place the housing back into the dust tank. Note: do not cl...
Should you run into any problem operating this product, use the table below to troubleshoot. If the problem persists, contact dihl or your retailer. The above table lists the most common problems regarding the operation of your product, with possible causes and solutions. Should there be any product...
In no event shall dihl or your supplier / retailer be liable to you or any other party for any direct, indirect, general, special, incidental, consequential, exemplary, or other damages, arising from the use or inability to use this product (including, without limitation, damages for injury, loss of...
