Dikom DBT-268 User Manual - page 9
DBT-268 Bluetooth GPS Receiver User’s Guide
Battery low -----------------------------------------------------------------
Red LED
flashing
Battery in charging --------------------------------------------------------
Green LED
steady on
Battery charging suspended (protection when
charge timer over or battery overheat) -----------------
Green LED
flashing
Charge completes or battery in normal capacity ---------------------- both LEDs off
Step 3: GPS acquisition
Turn the power switch “on.” The slide switch is on the top side of the body. Once the
power is turned on, both the Bluetooth and GPS indication LEDs start to flash.
Power Switch
Take the BT GPS to places with clear view of the sky. The
Red LED
indicates the status.
(a) LED steady on when power is connected and for the initial acquisition process;
(b) LED flashes at 1 second period when the receiver outputs position fix data.
Step 4: Wireless Link
Turn on the host device, a PDA or a NB with Bluetooth function. Then execute Bluetooth
manager program to perform “search” and “pair” procedures. The default PIN code is
“
0000
” for host devices to access this BT GPS unit (in paired mode).
The
Blue LED
indicates following Bluetooth radio status.
(a) LED flashes at 3 seconds interval for standby mode;
(b) LED flashes at 0.2 second interval for pairable mode;
(c) LED flashes at 1 second interval if there is an active RF link.
3.2 GPS Viewer for Testing
Install a GPS viewer program to host device. You may check the status of the GPS receiver
whenever you like to.
(a) Open GpsViewer on your PPC .
DBT-268 User’s Guide v1.0
8