Dillenger OPIA User Manual - Assembly—Pedal
USER MANUAL
OPIA
LAST UPDATED: 2/12/2016
12
All bicycles (electric bikes included) have left and right side pedals. Make sure
you identify each one. This image shows how to identify each pedal. You can see
the ‘R’ written on this pedal, denoting this is the right side pedal, to be used on the
right side of the bike (if you were sitting on the bike).
The right side pedal mounts to the right side crank (if you were sitting on the bike)
and left side pedal on the left crank. The right side pedal is a right hand thread, it
will tighten by turning clockwise (normal). The left side pedal is a left hand thread
and will tighten by turning anticlockwise (opposite normal). It is essential not to
confuse which pedal is used where and not to cross thread the pedal. If it feels
too tight, you might have made a mistake
ASSEMBLY—PEDAL
ASSEMBLY—SEAT
Assembling the seat is the simplest
process. Just open the seat post latch.
Slide in the seat post and close the latch at
the desire height. Remember to make sure
the maximum seat height marker is below
the seat clamp at all times.
If the seat post is sliding into the clamp
when the clamp is closed, you may need to
adjust the tension of the clamp. To do this while the clamp is open rotate the
clamp clockwise to tighten. Attempt to close clamp again at the desired
tightness. If you are unable to close the clamp is may be too tight and require
loosening. Check the maintenance document for more details.