Dimplex DF2550 Owner's Manual

Summary of DF2550

  • Page 1

    Owner’s manual model df2426gb df2426ss df2550 important safety information: always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damag...

  • Page 2: Table of Contents

    2 www.Dimplex.Com table of contents always use a qualified technician or service agency to repair this stove. ! Note: procedures and techniques that are considered important enough to emphasize. Caution: procedures and techniques which, if not carefully followed, will result in damage to the equipme...

  • Page 3: Welcome & Congratulations

    3 welcome & congratulations thank you and congratulations for choosing to purchase an electric fireplace from dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. Caution: read all instructions and warnings carefully before starting installation. Failu...

  • Page 4: Important Instructions

    4 www.Dimplex.Com ① read all instructions before using the electric fireplace. ② the heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation. Keep combustible materials, such as furniture, pillows, bedd...

  • Page 5: Save These Instructions

    5 save these instructions soft surfaces, like a bed, where openings may become blocked. ⑫ all electrical heaters have hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable vapors. ⑬ d...

  • Page 6: Important Instructions

    6 www.Dimplex.Com important instructions ! Note: this equipment has been tested and found to comply with the limits for class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation....

  • Page 7: Warning:  Ensure The

    7 ! Note 1: a 15 amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same...

  • Page 8: Fireplace Installation

    8 www.Dimplex.Com fireplace installation install the fireplace assembly 1. Into the mantel. (refer to mantel assembly instructions) ! Note 1: a 15 amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after instal...

  • Page 9: Fireplace Installation

    9 fireplace installation option #3 - hardwire wire a dedicated, properly 1. Fused circuit with 120 volt, 15 amp rating. Allow up to eight (8) feet of service cable for connecting power supply to junction box on fireplace when installing after finishing wall. Caution: use two conductor, non-metallic ...

  • Page 10: A. Main On/off Switch

    10 www.Dimplex.Com a. Main on/off switch the switch has two on positions marked. The “ -- “ position is for manual operation. In this position the built-in remote control is by-passed. The “ = “ position is for operating the unit with the provided remote control. When in remote control (“ = “) posit...

  • Page 11: Resetting The

    11 the thermostat knob counter- clockwise until you hear a click. Leave in this position to maintain the room temperature at this setting. For additional heat, turn clockwise until you hear the click again and the heater will turn on. Resetting the temperature cutoff switch should the heater overhea...

  • Page 12: Remote Control

    12 www.Dimplex.Com the hand held transmitter. Install one 12-volt (a23) 2. Battery in the battery holder. Close the battery cover. 3. Remote control initialization/ reprogramming in the event that your remote control ceases to operate your fireplace, follow these steps to re- initialize the hand-hel...

  • Page 13: Maintenance

    13 maintenance light bulb replacement allow at least five (5) minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin. Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log ember bed exterior disappears...

  • Page 14: Figure 7

    14 www.Dimplex.Com figure 7 side section front edge log ember bed back ledge rear tab maintenance replace the log set by 8. Inserting the front edge of the log set and push down on the rear edge of the ember bed until it snaps into place (figure 7). ! Note: ensure the log set is installed tightly un...

  • Page 15: Two Year Limited Warranty

    15 two year limited warranty products to which this limited warranty applies this limited warranty applies to your newly purchased dimplex electric fireplace. This limited warranty applies only to purchases made in any province of canada except for yukon territory, nunavut, or northwest territories ...

  • Page 16: Warranty

    16 www.Dimplex.Com accident, neglect, incorrect installation, improper maintenance or handling, or operation with an incorrect power source. What you must do to get service under this limited warranty defects must be brought to the attention of dimplex technical service by contacting dimplex at 1-88...

  • Page 17: Warranty

    17 authorized dealer’s or service agent’s place of business and all labour costs. Such costs shall not be the responsibility of dimplex. For surrounds (mantels) and trims • for the period ending at midnight on the first anniversary of the date of first purchase, dimplex will in its sole discretion e...

  • Page 18: Replacement Parts

    18 www.Dimplex.Com remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3000370500rp remote control reciever board . . . . . . . . . . . . . . . . . . . . . . 3000380200rp flicker motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20002102...