Service manual model dlg1058 part number 6908400100 7400600000r00 in keeping with our policy of continuous product development, we reserve the right to make changes without notice. © 2012 dimplex north america limited dimplex north america limited 1367 industrial road cambridge on canada n1r 7g8 1-8...
2 www.Dimplex.Com always use a qualified technician or service agency to repair this log grate. ! Note: procedures and techniques that are considered important enough to emphasize. Caution: procedures and techniques which, if not carefully followed, will result in damage to the equipment. Warning: p...
3 ensure child lock is in the “unlocked” position (figure 3. 2). Replace the battery cover. 4. ! Note: when the “bat”symbol is present on the remote control it is recommended to replace the batteries promptly, to maintain full functionality of the remote/log grate. The remote control has a battery b...
4 www.Dimplex.Com figure 3 - remote control functions a. Room temperature b. Set temperature c. Dimmer d. Flame speed control e. Sleep timer f. Flame & heat on/off g. Temperature down h. Temperature up i. Dimmer down j. Dimmer up k. Flame speed down l. Flame speed up m. Sleep timer down n. Sleep tim...
5 exploded parts diagram replacement parts list flicker motor 1. . . . . . . . . . . . . . . . . . . . . . . . . . .2000450100rp heater assembly (with cutout) 2. . . . . . . . . . . . .2203580100rp on/off switch 3. . . . . . . . . . . . . . . . . . . . . . . . . .2800070700rp power cord (with strain...
6 www.Dimplex.Com wiring diagram log harness connection flicker motor connection blower motor heating elements m thermal cutout n l main power switch.
7 power cord replacement tools required: philips head screwdriver needle-nose pliers flat head screwdriver warning: if the log grate was operating prior to ser- vicing, allow at least 10 minutes for light bulbs and heating elements to cool off to avoid accidental burning of skin. Warning: disconnect...
8 www.Dimplex.Com carefully remove the heater assembly out of the log 6. Grate leaving the wires still connected. Trace the heater wires to the remote control receiver. 7. Carefully replace the wire connections of the original 8. Heater assembly with the new heater assembly. ! Note: use a flat head ...
9 then push the switch outward. Alternatively, a flat head screw driver can be used to press the each mounting tab down individually and pushing the switch out, alternating sides until the switch is released from its position. Replace the original switch with the new switch, ensur- 8. Ing the correc...
10 www.Dimplex.Com problem cause solution general circuit breaker trips or fuse blows when unit is turned on short in unit wiring. Trace wiring in unit. Improper circuit current rating additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet o...
11 problem cause solution heater heater is not turning off improper operation refer to operation section defective remote control receiver replace remote control receiver. Initialize to re- mote control. Heater is not turning on improper operation refer to operation section loose wiring check wiring...
