- 1 - duo300n 1.3kw / 0.38kw 9.1kwh duo400n 1.95kw / 0.47kw 13.65kwh duo500n 2.6kw / 0.54kw 18.2kwh 87452 : 3 : april 2009 installation instructions.
- 2 - a a circuit diagram b charge control thermostat c over temperature cut out d storageheater elements f room sensing thermistor g core sensing thermistor h charge controller module i user interface module j peak supply k radiant element l live n neutral p pilot wire e manual fit connector l1 liv...
- 3 - g d e f 110mm 150mm min. 250mm min. 75mm min. 75mm min. A b c model modèle modelo modello model height hauteur altura altezza wys. Width largeur comprimento larghezza szer. Depth Épaisseur espessura profondità gleb. Duo300n 712mm 600mm 130mm+10mm duo400n 712mm 830mm 130mm+10mm duo500n 712mm 10...
- 4 - 2 1 5 6 4 1. Feet 2. Accessories bag 1. Pieds 2. Sac à accessoires 1. Pés 2. Saco de acessórios 1. Piedini 2. Sacchetto accessori 1. Nogo 2. Worek z akcesoriami 1 2 1 2 10mm 1 1 2 10 a 10 b.
- 5 - 1. 2. 3. 4. 5. 6. 7. 1. Brick 2. 8mm drill 3. 3” no. 10 screws (supplied) 4. Length +15mm 1. Brique 2. Foret 8mm 3. Vis n° 10 3” (fournies) 4. Longueur +15mm 1. Tijolo 2. 8mm broca 3. 3” no. 10 parafusos (forneci- dos) 4. Comprimento +15mm 1. Mattone 2. Punta da 8mm 3. Inserti in fi bra n. 10 ...
- 6 - 16 12 a 12 b 12 c 13 14 15 a 15 b.
- 7 - 2 1 18 b 18 19 a 19 b 19 c 19 e 19 f 18 a 19 d.
- 8 - english electrical connection warning – this appliance must be earthed the installation of this appliance should be carried out by a competent electrician in accordance with i.E.E. Regulations for electrical equipment. The radiator is fi tted with two fl exible cables for connection to the fi ...
- 9 - 5. Stand the radiator on its feet and against a wall. Remove the securing screws along the bottom edge of the front panel. (fig. 5) 6. Carefully swing bottom of panel slightly away from the rest of the radiator 1 , thus disconnecting the radiant element connector from the front panel, and lift...
- 10 - do not use 30mm spacer on inside of radiator. Use only externally - see fig. 11 a . Note: under no circumstances should these screws be removed without first removing all energy retention cells from the radiator 10 f once both sides have been successfully positioned screw the radiator fl ush ...
- 11 - 18. In its factory default setting, the radiant element will be allowed to operate for up to 2 hours after the beginning of the off peak charge period to maintain a comfortable room temperature if required. After 2 hours the radiant element will be automatically disabled until the end of the ...
- 12 - 2. To check the radiant panel operation (comfort heat). (i) adjust the temperature control display as follows; press down the + button until all red bars are illuminated (shown below). After 2 minutes the front panel should now feel warm, this will confi rm correct operation. (ii) if the fron...
