Service manual compact stove model numbers: cs3311 cs4416 cs2307 7400100000r03 rev pcn date 00 ~~~~ feb 12, 07 01 11563 aug 10, 09 02 11993 april 12, 10 03 sept 4, 12 in keeping with our policy of continuous product development, we reserve the right to make changes without notice. Dimplex north amer...
2 operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 exploded parts diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 r...
3 operation electric stove manual control the manual controls for the stove are located in the upper left hand corner on the rear of the stove (figure 1). A. 3 position switch the switch has two (2) on positions marked with and “ manual”. The “ manual” position is for manual operation. In this posit...
4 exploded parts diagram replacement parts list cs3311 part number 6901050100 cs2307 part number 6901051300 replacement part: 1. Log set assembly . . . . . . . . . . . . . . . . .0438500400rp 2. Flicker motor . . . . . . . . . . . . . . . . . . . . .2000210100rp 3. Heater assembly . . . . . . . . . ...
5 wiring diagram.
6 light bulb replacement allow at least five (5) minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin. Light bulbs need to be replaced when you notice a dark section of the flame. There are two (2) bulbs under the log set which generate the flames and embers. Dis...
7 2. Remove the 11 philips screws that attach the top panel to the stove as shown in figure 4. There are: four (4) screws along each side; and three (3) screws at the front, accessible behind the door. 3. Remove top panel. 4. Locate switch to be replaced and disconnect the wiring clips, noting their...
8 17. Connect the three (3) wires from the new motor to the terminal block as they originally were (refer to figure 8). 18. Follow steps 1 through 8 in reverse order to reassemble the stove. Remote control receiver replacement the remote control requires no replacement procedure however, a reinitial...
9 wire clips disconnected in step 6. 10. Follow steps 1 through 4 in revers order to reassemble the stove. Heater assembly/cutout replacement if the stove was operating prior to servicing allow at least 10 minutes for light bulbs and heating element to cool off to avoid accidental burning of skin. D...
10 that hold the heater assembly in place from the bottom surface of the pan (figure 13). 8. Remove the two (2) black metal stand off brackets from the heater assembly by removing the two (2) philips screws that hold each bracket in place. 9. Remove the black metal baffle that surrounds the heater a...
11 figure 16 screws to remove (2) figure 17 figure 18 ribbed edge to left terminal of remote control receiver smooth edge to center terminal of 3 position on/off switch left terminal of the remote control receiver, the smooth edged cord connects to the center terminal of the 3 position switch (figur...
12 problem cause solution general circuit breaker trips or fuse blows when unit is turned on short in unit wiring. Trace wiring in unit. Improper circuit current rating additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit o...
13 problem cause solution heater heater is not turning off improper operation refer to operation section defective heater on/off switch replace heater on/off switch defective thermostat replace thermostat heater is not turning on, but flame effect is still functioning improper operation refer to ope...
