Summary of KH 2295
Page 1
Rds radio alarm kh 2295 operatinginstructions t.
Page 3
Q w r e t y u i o a s d f g h j k l 1( 2! 2! 2# 2$ 2% 2@.
Page 5: Index
1. Intended use .................................................................................................................................. 7 2. Technical data ................................................................................................................................ 7 3....
Page 6
12. Connecting headphones to the rds radio alarm .................................................................. 19 13. Cleaning the rds radio alarm ............................................................................................... 19 14. Troubleshooting ................................
Page 7: Rds Radio Alarm
Rds radio alarm e-bench kh 2295 1. Intended use the rds radio alarm is intended exclusively … Ú for the reception of vhf/fm radio stations Ú as an alarm Ú for stationary operation in covered areas Ú for private, non-commercial applications. 2. Technical data power supply: 230 v ~ / 50 hz, 5 w recept...
Page 8: ™
Given in the warranty card. The warranty card is supplied with the appliance. † danger! Equipment connected to a power supply can be damaged during a thunderstorm. Thus: Ú during a thunderstorm, always remove the plug from the power socket. Ú the power socket should be close to the ap- pliance and e...
Page 9
Q headphone connection socket “earphone” for the connection of headphones with a 3,5 mm jackplug w operational state display e button “snooze” for short term interruption of the alarm signal r volume controller “volume” t button “nap timer” to activate adjustment of the siesta timer y button “sleep”...
Page 11
Ú the time display from the pre-programmed time “2:00” Ú the date display fronm the pre-programmed date “01-01-07”. In these cases you can … Ú search for an rds radio station manually. This is explained in chapter 8.1.2 “manually setting and saving radio stations”. Ú select an rds radio station from...
Page 12: 8. Using The Rds Radio Alarm
With the buttons o resp. A you can switch between both display formats. 11 when the desired indicator format is blink- ing in the display d : wait for ca. 10 sec- onds, without pressing a button. The dis- play d returns to its normal status; the time is now shown in the selected display format. The ...
Page 13
Ú button “3/8” j – for selection of 3 resp. 8 as the second digit of the programme position Ú button “4/9” h – for selection of 4 resp. 9 as the second digit of the programme position when the desired programme position number for the tuned radio station is shown in the display d : 5 press the butto...
Page 14
Example: to select the radio station saved at programme position 26: 1 repeatedly press the button “group wec” f . As soon as a radio station in the pro- gramme position group 20 (20 bis 29) is shown in the display d : 2 repeatedly press the button “1/6” l until programme position 26 is shown in the...
Page 15
Mon æ monday tue æ tuesday wed æ wednesday thu æ thursday fri æ friday sat æ saturday sun æ sunday ô note: to carry out the steps 2 to 7 you have ca. Ten seconds for each step. If one step is delayed, you must start again from step 2. 2 press the button “al1” 2! Again. On the lower edge of the displ...
Page 16
8 press the button “al1” 2! Once. In the display d the rds radio alarm symbol for the alarm call type radio blinks. Press the buttons o resp. A to switch between the three alarm call types. 9 when you have selected the desired alarm call type: press the button “al1” 2! Once. The programming for alar...
Page 17
2 to switch the alarm functions for week- ends back on again: press the button “group wec” f once more. In the display d the indicator “wec” extinguishes. 8.3 using the timer functions of the rds radio alarm 8.3.1 programming the sleep timer with the sleep timer switched on, the radio automatically ...
Page 18: 9. Adjusting The Display
On the selected date the alarm tone of the rds radio alarm reminds you of the programmed appointment. The reminder sounds hourly between 08:00 and 23:00. Thereby, the alarm tone remains switched on for 10 minutes. To interrupt the alarm tone: press any button. The alarm tone sounds again on the next...
Page 19: 10. Returning The Rds Radio
10. Returning the rds radio alarm to factory settings to return the rds radio alarm to factory set- tings and to erase all programing that has been carried out: 1 turn the rds radio alarm so that the underside of it is visible to you. 2 with a pen/pencil (or other sharp pointed object) press the but...
Page 20: 15. Disposal
C check to see if the button lock of the rds radio alarm is activated. See chapter 11. “switching on the button lock”. D disconnect the rds radio alarm from the power supply. Wait a few seconds, then re- connect it. Check to see if the malfunction is still extant. ô note: be aware that programming a...
Page 21: 16. Warranty & Service
Dispose of the appliance through an approved disposal centre or at your community waste fa- cility. Observe the currently applicable regulations. In case of doubt, please contact your local waste disposal centre. 16. Warranty & service please read the conditions for warranty and take note of the ser...
Page 22
Kompernaß gmbh · burgstraße 21 · d-44867 bochum www.Kompernass.Com id no.: kh2295-012/06-v3 c.