E-Bike Bofeili Owner's Manual - page 9
9
www.BofeiliUSA.com
© e-Bikes USA 2012
If rubbing occurs of one of the brake pads, first check that the wheel is properly running true. If not,
adjust on the forks. The friction style brakes exert the most stopping power at the point just before
locking the wheel in place. Rain, oil, or wet conditions will cause less friction and therefore you should
anticipate longer braking time than in dry conditions. The pads should be adjusted to strike the wheel rim
with the maximum amount of rubber to wheel alignment. Pads do wear over time and should be reviewed
in your routine inspections.
Your Bofeili e-Bike is equipped with quick adjusting brake cable nuts near the handle grips. Loosen the
locking nut and twist the adjustment nut to shorten or lengthen the cable which will draw the brake pads
closer or further from the wheel rim.
Fine adjustments of the brake arms can be done with a small
screwdriver tightening or loosening the Spring Adjustment Screw
locate as the diagram indicates. Adjust using small amounts.
Tektro brakes on the Sport e-Bike
The Sport model e-Bike has hydraulic disc brakes designed and
manufactured by Tektro. Service information, adjustment and
maintenance for these brakes can be found at
www.Tektro.com
.
Please match the exact model on the individual e-Bike to the
service and use on the Tektro company web site.
Controls
The Bofeili e-Bike is equipped with a right hand throttle that twists, similar to a motorcycle throttle.
When the power mode is on, the controller will sense the need for electric assistance after the second
pedal revolution and provide assistance depending on your level set, “Low, Medium, High”. This
assistance will be terminated at the end of pedaling or at braking. Additional power with or without
pedaling can be sent to the motor with a twist of the throttle. If you desire no battery assistance, turn the
control off.
On/Off
Battery Level
Mode: Level of desired power