E-Bikeboard Allrounder User Manual - page 12
23
3. E-Bikeboard
Features
3.1 Batteries
Basics
The batteries used on the E-Bikeboard are based on Lithium technology. These batteries are
designed using the latest technology for high power density, low weight and a long life
span.
Before using the E-Bikeboard for the first time, please charge both Batteries until the green
LED on the charger unit lights up (approximately 4.5 hours with the standard charger).
Always turn off the batteries with the Switch when you store the E-Bikeboard for longer than
1 day! Otherwise the battery will be empty in a few days.
Battery LED Read Out
Use the button in the middle (1) to turn on the LED interface. There are 5 LED lights, which
show the remaining battery capacity:
80% - 100%
60% - 80%
40% - 60%
20% - 40%
5% - 20%
Blinking
0% - 5%
Note:
•
The LED’s turn on automatically in use (drive or charge)
1
Page 24 of 44
Charging of Batteries
The batteries can be charged on or off the E-Bikeboard.
If you charge on the E-
Bikeboard, then make sure both batteries are turned on, so both will be charged and
balanced. So you can use also only one charger to charge both batteries together. Also
two charger can be used, so the charge time will be half.
Procedure for Charge:
A) Turn off batteries at the main switch
B)
Plug in the charger at the supply side (110 or 240VAC), make sure the charger
was unplugged before and LED1 and LED2 are off.
C) After this, plug in charger to the battery (see picture on the left).
D) Turn on the battery (or both if charged on the E-Bikeboard)
E)
Now the LED2 turn on red, also the fan noise can be noticed and the LED start to
blinking according the table below.
F)
Charge until the LED2 of the charger turn to green. This can take up to 4.5h, until
the batteries are fully charged (or 9h if both batteries are charged together on
the E-Bikeboard with a 2Amp charger)
G) After the charger LED2 turned to green, make sure the batterie also show full (all
4 green and the red LED are on)
H) Make sure that after charge close the charge socket again with the rubber
protection and the charger is unplugged from the power supply.
Blinking
80% - 100%
Blinking
60% - 80%
Blinking
40% - 50%
Blinking
20% - 40%
Blinking
0% - 20%