E.C.A. CMT707 User Manual - Eng
10
This section shows you how to setup and run the thermostat in 3 simple steps:
STEP 1: Installing the Batteries
Note: if the ‘Low Battery’ Indicator
is showing or the thermostat screen is blank
(no symbols or digits are displayed) replace the batteries as follows, otherwise,
please go directly to Step 2: Setting the Date and Time.
To install the Batteries:
a. Liftupthefrontcoverofthethermostattorevealthebatterycoverandproduct
controls.
b.Removethebatterycoverbypressingdownandslidingout.
c. Insertthe2xAALR6AlkalineBatteriessuppliedwiththethermostat,ensuring
thecorrectorientation(see‘
Controls Layout’onpage9).
d.Afterashortpausethethermostatwilldisplayinformationonthescreenandis
nowreadyforuse.
e. Replacethebatterycoverbyslidingitfirmlybackintothefrontofthethermostat.
STEP 2: Setting the Day and Time
To set the Day and Time:
a. PresstheDAYbuttononceandthe‘dayindicator’willbegintoflash.
b.PresstheDAYbuttonuntilthecorrectdayisreached(Day1=Monday).Press
thegreen
buttontoconfirm.
d.Presseitherofthe or buttonsoncetoentertimesettingmode.TheLCD
screenflashesthetimedigits(whentheunitispoweredforthefirsttimethe
displayshows12:00).
e. Usethe or buttonstosetthecorrecttimethenpressthegreen
button
toconfirm.Eachpressofthebuttonswillchangethetimebyoneminuteand
holdingthemdownwillchangethetimeslowlyatfirstandgetprogressively
quicker.
Note: If this mode is entered accidentally then press the AUTO, MAN or OFF buttons
to exit.
STEP 3: Running the Built-in Heating Program
Thethermostatisnowreadyforoperation.Pressthe
AUTO buttonandthebuilt-in
heatingprogramwillstartrunning.Note: The built-in heating program has been
designed to provide normal comfort requirements, but if you want to customise the
settings please see the next section ‘Programming the CMT707’.
PLEASE RESPECT YOUR ENVIRONMENT! Take care to dispose of used batteries carefully.
SETTING-UP THE CMT707
‘Getting Started’