E.F. Johnson 5100 SERIES Operating manual - page 33
CONVENTIONAL MODE FEATURES
33
3. Press the PTT switch or the F2 key and one of the
following occur:
•
If five beeps sound, the system received the page
and the paged mobile is on the air and received it.
The page mode is automatically exited.
•
If the system received the page but the called
mobile is not on the air, a single beep sounds and
“NO ACK” is displayed 6 seconds after the PTT
switch is pressed. Auto exit then occurs.
5.16.7 MESSAGING
The messaging feature* allows preprogrammed
messages to be sent to a dispatcher on P25 channels.
Up to 16 messages can be preprogrammed, and they
are identified by an alias. If a Message option switch
or menu parameter is programmed, messages are sent
as follows:
1. Momentarily press the Message option switch or
select that menu parameter. The alias of the last
message sent is displayed.
2. If required, press the Up/Down switch to display the
desired message. Then send the message by
pressing the F2 key or momentarily pressing the
PTT switch. One of the following events then
occurs:
•
If five beeps sound and “ACK RECVD” is
displayed, the message was received and automat-
ically acknowledged by the system.
•
If after five tries the message is not acknowledged,
a tone sounds and “NO ACK” is displayed.
5.16.8 STATUS MESSAGING
The status feature* allows you to manually or
automatically send your current status to your
dispatcher on P25 channels. Up to eight status condi-
tions can be preprogrammed, and they are identified
by an alias. If the Status option switch or menu param-
eter is programmed, status conditions are sent as
follows:
1. Momentarily press the Status option switch or select
that menu parameter. The alias of the current status
condition is displayed.
2. To change the current status, press the Up/Down
switch until the desired status is displayed. Then to
send the status, press the F2 (Select) switch or
momentarily press the PTT switch. One of the
following events then occurs:
•
If five beeps sound and “ACK RCVD” is
displayed, the status was received and acknowl-
edged by the system.
•
If after five tries the message is not acknowledged,
a tone sounds and “NO ACK” is displayed.
Figure 5-1 Keypad Programming Menu
Flowchart
5.17 KEYPAD PROGRAMMING
NOTE: The Keypad programming feature is available
to Federal Government users only. Users regulated by
the Federal Communications Commission are not
allowed to have this feature.
5.17.1 INTRODUCTION
Keypad programming can be enabled only with
transceivers that have been factory coded as Federal
models. It is then available if a conventional mode
option switch or menu parameter is programmed for
the “Keypad Programming” function. The keypad
programming mode is indicated by “CHNG ZONE”
and
in the display.
Zone
Channel
Change
Change
System
Parameters
Channel
Parameters
Select
Zone
Select
Channel
Scan Hold Timer
Tx Timer
Penalty Timer
Conver. Timer
Rx Freq
Tx Freq
Rx Code/NAC
Tx Code/NAC
Tx Power
Tx Tmr On-Off
Squelch Adj*
Chan Spacing*
F1 = Select
F2 = Exit/Back
Up/Down = Scroll
Tlk Grp Sel**
* Analog Only ** Digital Only
*
This feature requires 51xx operating (Flash) software
1.8.0 or later and PCConfigure 1.19 or later.