Umx ™ vapor ® lite hp instruction manual bedienungsanleitung manuel d’utilisation manuale di istruzioni.
Welcome to an exciting new world of fl ying possibilities. Bedrooms, conference rooms, garages, basements, break rooms, offi ces–all can be transformed into aerial rc playgrounds with the umx ™ vapor ® lite hp. Its small size, negligible mass and proportional 3-channel control will let you confi dently...
Table of contents charging warnings................................................4 charging the battery .............................................5 installing transmitter batteries ..............................6 transmitter and receiver binding ..........................6 installing the flight...
Low voltage cutoff (lvc) when a li-po battery is discharged below 3v per cell, it will not hold a charge. The aircraft’s esc protects the fl ight battery from over-discharge using low voltage cutoff (lvc). Before the battery charge decreases too much, lvc removes power supplied to the motor. Power to...
Charging the battery notice: charge only batteries that are cool to the touch and are not damaged. Look at the battery to make sure it is not damaged e.G., swollen, bent, broken or punctured. Caution: only use chargers specifi cally designed to charge the included li-po battery. Failure to do so coul...
Binding is the process of programming the receiver of the control unit to recognize the guid (globally unique identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen spektrum ™ dsm ® technology equipped aircraft transmitter to the receiver for proper operation. For a list o...
Prefl ight checklist installing the flight battery and arming the esc 1. Charge the fl ight battery. 2. Turn on the transmitter. 3. Install the fl ight battery in the aircraft (once it has been fully charged). 4. Make sure the linkages move freely. 5. Perform the control direction test with the transmi...
Transmitter control digital trims the e-flite ® 4-channel dsm2 ® /dsmx ® transmitter features digital trim buttons on all controls to make fi ne adjustments. The digital trims are used to fi ne-tune the model’s fl ight path when in fl ight. Before the fi rst fl ight, center the control surfaces mechanical...
Bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure aircraft control surfaces move correctly. Always keep throttle at the low position during testing. Control direction test down elevator right rudder left rudder up elevator 9 en.
Before fi rst fl ights, or in the event of an accident, make sure the fl ight control surfaces are centered. Adjust the linkages mechanically if the control surfaces are not centered. Use of the transmitter trims may not correctly center the aircraft control surfaces due to the mechanical limits of lin...
The cg location is 50mm back from the leading edge of the center of the wing. This cg location has been determined with the included 1s 70mah 3.7v li-po battery installed in the battery holder. Balance the model on the edge of a metal ruler to fi nd the center of gravity. Place the ruler on the under...
Caution: do not handle propeller parts while the fl ight battery is connected. Personal injury could result. Disassembly 1. Disconnect the battery from the esc/receiver. 2. Hold the spur gear and turn the propeller counterclockwise (looking from the front of the model) to remove. Turn the propeller c...
We recommend fl ying your aircraft indoors with a fl oor area of 15 ft x 15 ft and a minimum ceiling height of 8 ft; a living room or offi ce is ideal. We suggest fi rst fl ights take place in a larger area, like a garage or basement. We do not recommend fl ying outdoors unless the conditions are absolute...
Troubleshooting guide problem possible cause solution aircraft will not respond to throttle but re- sponds to other controls throttle stick and/or throttle trim is too high reset controls with throttle stick and throttle trim at lowest setting throttle channel is reversed reverse throttle channel on...
Troubleshooting guide (continued) problem possible cause solution controls reversed transmitter settings reversed do the control direction test and adjust controls on transmitter appropriately motor loses power damage to motor or power components do a check of motor and power compo- nents for damage...
Limited warranty what this warranty covers – horizon hobby, llc, (horizon) warrants to the original purchaser that the product purchased (the “product”) will be free from defects in materials and workmanship at the date of purchase. What is not covered – this warranty is not transferable and does no...
Warranty and service information country of purchase horizon hobby contact information address united states of america horizon service center (repairs and repair requests) servicecenter.Horizonhobby.Com/ requestform/ 4105 fieldstone rd champaign, illinois, 61822 usa horizon product support (product...
Compliance information for the european union instructions for disposal of weee by users in the european union this product must not be disposed of with other waste. Instead, it is the user’s responsibility to dispose of their waste equipment by handing it over to a designated collections point for ...
70 it replacement parts • ersatzteile • pièces de rechange • pezzi di ricambio part # • nummer numéro • codice description beschreibung description descrizione eflu6800 umx vapor lite hp rtf umx vapor lite hp rtf umx vapor lite hp rtf umx vapor lite hp rtf eflu6800m1 umx vapor lite hp rtf md1 umx va...
71 it optional parts and accessories • optionale bauteile und zubehör • pièces et accessoires optionnels • componenti e accessori opzionali part # • nummer numéro • codice description beschreibung description descrizione eflc1005/au/ eu/uk ac to 6v dc 1.5 amp power supply (based upon your sales regi...
© 2017 horizon hobby, llc. E-flite, vapor, as3x, dsm, dsm2, dsmx, bind-n-fly, bnf, the bnf logo, modelmatch, and the horizon hobby logo are trademarks or registered trademarks of horizon hobby, llc. The spektrum trademark is used with permission of bachmann industries, inc. Futaba is a registered tr...