1. DL manuals
  2. E-FLITE
  3. Toy
  4. P-40 Warhawk 300
  5. Assembly Manual

E-FLITE P-40 Warhawk 300 Assembly Manual

Summary of P-40 Warhawk 300

  • Page 1

    Specifications wingspan: 25.6 in (650mm) wing area: 108 sq in (7.02 sq dm) length: 21.7 in (550mm) weight (without battery): 5.5–6.0 oz (156–170 g) weight (with li-po battery): 6.5–7.0 oz (184–198 g) p-40 warhawk 300 arf assembly manual.

  • Page 2

    2 e-flite p-40 warhawk assembly manual product registration register your product online at: www.E-fliterc.Com/register/ contents of kit/parts layout efl6076 fuselage with tail and hatch efl6077 main wing efl6078 propeller (2) efl6079 spinner efl6080 motor efl6081 canopy hatch efl6082 wing mount o-r...

  • Page 3

    3 e-flite p-40 warhawk assembly manual recommended radio equipment you will need a minimum 4-channel transmitter, receiver, and two servos. You can also choose to purchase a complete radio system. If you are using an existing transmitter, just purchase the other required equipment separately. We rec...

  • Page 4

    4 e-flite p-40 warhawk assembly manual 2. Use a hobby knife with a #11 blade to cut a narrow notch at the edge of the servo pocket in the wing to allow the servo wire from the aileron servo to fit in. 3. Press the servo into the servo pocket in the wing. Make sure to guide the servo wire into the no...

  • Page 5

    5 e-flite p-40 warhawk assembly manual 7. Plug the speed control and elevator servo connectors into the receiver. 8. Place a small piece of two-sided tape on the receiver. Slide the receiver into the fuselage and press it against the tape to secure it into the fuselage. Make sure to leave enough of ...

  • Page 6

    6 e-flite p-40 warhawk assembly manual linkage connections required parts fuselage assembly wing assembly flight battery transmitter single-sided servo horn double-sided servo horn required tools ruler flat blade screwdriver phillips screwdriver: #0 hobby knife with #11 blade 1. Inspect the clevis a...

  • Page 7

    7 e-flite p-40 warhawk assembly manual 6. Use a hobby knife to enlarge the holes in a double-sided servo horn that is 1/2-inch (13mm) from the center of the servo horn. The hole needs to be big enough to insert the pushrod wires for the ailerons. Use care not to make the hole too large as this will ...

  • Page 8

    8 e-flite p-40 warhawk assembly manual wing installation required parts fuselage assembly wing assembly o-ring tool before installing the wing stretch the o-ring slightly by holding the base of the mount in the wing and pulling tension on the o-ring. Do not use much force as you could damage the win...

  • Page 9

    9 e-flite p-40 warhawk assembly manual battery installation required parts assembled airframe motor battery 1. Slide the motor battery into the fuselage. It should slide in easily with little force. 2. When you are ready to fly your aircraft, connect the lead from the battery to the lead from the sp...

  • Page 10

    10 e-flite p-40 warhawk assembly manual propeller and spinner removal and replacement required parts fuselage assembly propeller spinner required tools nut driver: 5mm canopy glue 1. Carefully pull the spinner forward to remove it from the motor. It will take a small amount of force to remove. 2. Us...

  • Page 11

    11 e-flite p-40 warhawk assembly manual 6. Next, slide the washer back on the motor shaft. Thread the 5mm locknut back on the shaft. 7. Use a 5mm nut driver to tighten the nut holding the propeller on the motor. 8. Apply a small amount of canopy glue to the nut. Use a small amount so the spinner can...

  • Page 12

    12 e-flite p-40 warhawk assembly manual 2. The mount for the plane can swivel on the display stand strut. This allows you to position your model for the best dramatic effect while on display. 3. The plane will rest on the mount. The straight pin on the mount is inserted into the hole in the area of ...

  • Page 13

    13 e-flite p-40 warhawk assembly manual aileron high rate up 5/16-inch (8mm) down 5/16-inch (8mm) aileron low rate up 1/2-inch (6mm) down 1/2-inch (6mm) elevator high rate up 3/16-inch (5mm) down 3/16-inch (5mm) elevator low rate up 5/32-inch (4mm) down 5/32-inch (4mm) measurements are taken at the ...

  • Page 14

    14 e-flite p-40 warhawk assembly manual range test your radio 1. Before each flying session, be sure to range check your radio. See your radio manual for the recommended range and instructions for your radio system. Each radio manufacturer specifies different procedures for their radio systems. Next...

  • Page 15

    15 e-flite p-40 warhawk assembly manual safety, precautions and warnings as the user of this product, you are solely responsible for operating it in a manner that does not endanger yourself and others or result in damage to the product or the property of others. Carefully follow the directions and w...

  • Page 16

    16 e-flite p-40 warhawk assembly manual questions, assistance, and repairs your local hobby store and/or place of purchase cannot provide warranty support or repair. Once assembly, setup or use of the product has been started, you must contact horizon directly. This will enable horizon to better ans...

  • Page 17

    17 e-flite p-40 warhawk assembly manual ce compliance information for the european union instructions for disposal of weee by users in the european union this product must not be disposed of with other waste. Instead, it is the user’s responsibility to dispose of their waste equipment by handing it ...

  • Page 18

    18 e-flite p-40 warhawk assembly manual 4. At all flying sites a line must be established, in front of which all flying takes place. Only personnel associated with flying the model aircraft are allowed at or in front of the line. In the case of airshows demonstrations straight line must be establish...

  • Page 19

    19 e-flite p-40 warhawk assembly manual.

  • Page 20

    Printed 04/09 15659 © 2009 horizon hobby, inc. 4105 fieldstone road champaign, illinois 61822 u.S.A. (877) 504-0233 horizonhobby.Com e-fliterc.Com.