- DL manuals
- E-FLITE
- Toy
- Pawnee Brave Night Flyer EFL6950
- Instruction Manual
E-FLITE Pawnee Brave Night Flyer EFL6950 Instruction Manual
Summary of Pawnee Brave Night Flyer EFL6950
Page 1
Pawnee brave night flyer instruction manual bedienungsanleitung manuel d’utilisation manuale di istruzioni.
Page 2: 14+
En as the user of this product, you are solely responsible for operating in a man- ner that does not endanger yourself and others or result in damage to the product or the property of others. • always keep a safe distance in all directions around your model to avoid collisions or injury. This model ...
Page 3: Box Contents
En to register your product online, visit www.E-fl iterc.Com box contents quick start information transmitter setup set up your transmitter using the transmitter setup chart dual rates hi rate low rate ail =15mm =10mm =10mm =08mm ele =15mm =10mm =12mm =9mm rud =18mm =18mm =10mm =10mm flap...
Page 4: Prefl Ight
En prefl ight 1 remove and inspect contents. 2 read this instruction manual thoroughly. 3 charge the fl ight battery. 4 setup transmitter using transmitter setup chart. 5 fully assemble the airplane. 6 install the fl ight battery in the aircraft (once it has been fully charged). 7 check the center of g...
Page 5: Model Assembly
En model assembly tail installation 1. Connect the light connector (servo style) from the horizontal stab to the fuselage. 2. Install the horizontal stab to the fuselage with the control horn facing down. 3. Connect the internal light connector (jst style) from the vertical fi n to the connector comi...
Page 6: Model Assembly Continued
En model assembly continued wing assembly 1. Slide the left and right wing halves together, as shown (fi gure a). 2. Ensure the internal wing lights connectors (jst type connector), aileron servo connectors and navigation light connectors are aligned with the hole (b) created by the two connected win...
Page 7: Model Assembly Continued
En model assembly continued b a wing installation 2. Guide the aileron servo connectors, wing light and navigation light connec- tors (a) from the wing through the hole in the bottom side of the fuselage. Important: the ailerons must be connected to the receiver’s aile (#2 chan- nel) with a y-harnes...
Page 8: Model Assembly Continued
En clevis installation • pull the tube from the clevis to the linkage. • carefully spread the clevis, then insert the clevis pin into the desired hole in the control horn. • move the tube to hold the clevis on the control horn. Control surface centering after assembly and transmitter setup, confi rm ...
Page 9: Model Assembly Continued
En model assembly continued optional flap installation before you begin you will need to purchase (2) (spma330) servos and a 6 inch y-harness (spma3058) to complete the fl ap installation process. 1. Remove the main wing from the fuselage. 2. Install the servo arm included with the servos, angled rea...
Page 10
En binding is the process of programming the receiver to recognize the guid (globally unique identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen spektrum ™ dsm2 ® /dsmx ® technology equipped aircraft transmitter to the receiver for proper operation. Important: before bi...
Page 11
En battery installation and esc arming battery selection we recommend the e-fl ite ® 2200mah 11.1v 3s 30c li-po battery (eflb22003s30). Refer to the optional parts list for other recommended batteries. If using a battery other than those listed, the battery should be within the range of capacity, dim...
Page 12: Center of Gravity (Cg)
En center of gravity (cg) the cg location is measured from the leading edge of the wing at the root. This cg location has been determined with the recommended li-po battery (eflb22003s30) installed all the way forward in the battery compartment. The easiest way to achieve cg is to balance the aircra...
Page 13: Flying Tips and Repairs
En flying tips and repairs consult local laws and ordinances before choosing a fl ying location. Flying field always choose a wide-open space for fl ying your aircraft. It is recommended that you fl y at a designated rc fl ying fi eld. Always avoid fl ying near houses, trees, wires and buildings. Avoid fl ...
Page 14: Troubleshooting Guide As3X
En troubleshooting guide as3x problem possible cause solution oscillation damaged propeller or spinner replace propeller or spinner imbalanced propeller balance the propeller. For more information, view our propeller balancing video on horizon hobby’s you- tube channel https://www.Youtube.Com/watch?...
Page 15: Troubleshooting Guide
En problem possible cause solution aircraft will not re- spond to throttle but responds to other controls throttle not at idle and/or throttle trim too high reset controls with throttle stick and throttle trim at lowest setting throttle servo travel is lower than 100% make sure throttle servo travel...
Page 16
En ama national model aircraft safety code effective january 1, 2014 a. General a model aircraft is a non-human-carrying aircraft capable of sustained fl ight in the atmosphere. It may not exceed limitations of this code and is intended exclusively for sport, recreation, education and/or competition....
Page 17: Limited Warranty
En limited warranty what this warranty covers horizon hobby, llc, (horizon) warrants to the original purchaser that the product purchased (the “product”) will be free from defects in materials and workmanship at the date of purchase. What is not covered this warranty is not transferable and does not...
Page 18: Contact Information
En compliance information for the european union contact information country of purchase horizon hobby phone number/email address address united states of america horizon service center (repairs and repair requests) servicecenter.Horizonhobby.Com/ requestform/ 4105 fieldstone rd champaign, illinois,...
Page 20
? 2015 horizon hobby, llc. E-fl ite, as3x, dsm, dsm2, dsmx, the dsmx logo, bind-n-fly, z-foam, modelmatch, ec3, celectra, prophet and the horizon hobby logo are trademarks or registered trademarks of horizon hobby, llc. The spektrum trademark is used with permission of bachmann industries, inc. Futab...