1. DL manuals
  2. E-FLITE
  3. Toy
  4. UMX F4U corsair
  5. Instruction Manual

E-FLITE UMX F4U corsair Instruction Manual - Declaration of Conformity

Summary of UMX F4U corsair

  • Page 1

    Instruction manual bedienungsanleitung manuel d’utilisation manuale di istruzioni umx ™ f4u corsair lt.Jg. Kepford lt.Jg. Kepford.

  • Page 2

    2 en warning: read the entire instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This is a sophisticated hobby product. It must be operated ...

  • Page 3: Table of Contents

    3 en t hank you for purchasing the e-fl ite ® umx ™ f4u corsair, featuring trim schemes from two of the most prolifi c pilots to fl y the prized corsair, gregory “pappy” boyington and ira “ike” kepford. Now featuring as3x ® technology, the ultra micro f4u corsair provides the smooth, locked-in fl ight p...

  • Page 4: Prefl Ight Checklist

    4 en 1. Charge fl ight battery. 2. Install fl ight battery in aircraft (once it has been fully charged). 3. Bind aircraft to transmitter. (bnf only) 4. Make sure linkages move freely. 5. Perform control direction test with transmitter. 6. Set dual rates and expos. 7. Adjust center of gravity. 8. Perfo...

  • Page 5: Battery Charging

    5 en your aircraft comes with a 1s 3.7v dc li-po battery charger and 1s 3.7v 150mah 25c li-po battery. Refer to the charging warnings. It is recommended to charge the battery pack while you are inspecting the aircraft. The fl ight battery will be required to confi rm proper aircraft operation in futur...

  • Page 6

    6 en binding is the process of programming the receiver to recognize the guid (globally unique identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen spektrum ™ dsm ® technology equipped aircraft transmitter to the receiver for proper operation. For a list of compatible ds...

  • Page 7: Transmitter Control

    7 en the e-fl ite ® 4-channel dsm2/dsmx transmitter features digital trim buttons on all controls to make fi ne adjustments. The digital trims are used to fi ne-tune the model’s fl ight path when in fl ight. Before the fi rst fl ight, center the control surfaces mechanically (see control centering). When p...

  • Page 8

    8 en flight battery installation and esc arming arming the esc also occurs after binding as previously described, but subsequent connection of a fl ight battery requires the following steps. As3x the as3x ® system will not activate until the throttle stick or trim is increased for the fi rst time. Onc...

  • Page 9: Control Direction Test

    9 en bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure aircraft control surfaces move correctly. Always keep throttle at the low position during testing. Down elevator left aileron right aileron right rudder left rudder up elevator control...

  • Page 10: Control Centering

    10 en before the fi rst fl ights, or in the event of an accident, make sure the fl ight control surfaces are centered. Adjust the linkages mechanically if the control surfaces are not centered. Use of the transmitter sub-trims may not correctly center the aircraft control surfaces due to the mechanical...

  • Page 11: Flying Tips and Repairs

    11 en we recommend fl ying your aircraft outside in calm conditions. Always avoid fl ying near houses, trees, wires and buildings. You should also be careful to avoid fl ying in areas where there are many people, such as busy parks, schoolyards or soccer fi elds. Consult local laws and ordinances before...

  • Page 12: Landing Gear Removal

    12 en to remove the factory-installed landing gear: 1. Lift the end of the landing gear wire above the stop. 2. Gently pull the landing gear toward the center of the wing and away from the clips. Install in reverse order, making sure the end of the landing gear wire is inside the stop and the vertic...

  • Page 13: Power Components Service

    13 en power components service 112 x 90 caution: do not handle propeller parts while the fl ight battery is connected. Personal injury could result. Disassembly 1. Disconnect the battery from the esc/receiver. 2. Carefully cut the tape and decals on the side of the fuselage and behind the canopy to r...

  • Page 14: As3X

    14 en as3x problem possible cause solution control surfaces not at neutral position when transmitter controls are at neutral control surfaces may not have been mechanically centered from factory center control surfaces mechanically by adjusting the u-bends on control linkages aircraft was moved afte...

  • Page 15: Limited Warranty

    15 en problem possible cause solution led on receiver fl ashes rapidly and aircraft will not respond to transmit- ter (after binding) less than a 5-second wait between fi rst powering on transmitter and connecting fl ight battery to aircraft leaving transmitter on, disconnect and reconnect fl ight batte...

  • Page 16: Fcc Information

    16 en of horizon. Proof of purchase is required for all warranty claims. Service or replacement as provided under this warranty is the purchaser’s sole and exclusive remedy. Limitation of liability horizon shall not be liable for special, indirect, incidental or consequential damages, loss of profit...

  • Page 17: Declaration of Conformity

    17 en declaration of conformity compliance information for the european union robert peak chief financial offi cer horizon hobby, llc warranty and service information instructions for disposal of weee by users in the european union this product must not be disposed of with other waste. Instead, it is...

  • Page 18

    67 replacement parts – ersatzteile – – pièces de rechange – pezzi di ricambio – part # • nummer numéro • codice description beschreibung description descrizione pkzu1602 decal sheet: um f4u corsair dekorbogen: um f4u corsair planche de décal- comanies : um f4u corsair foglio con decalco- manie: um f...

  • Page 19

    68 – optional parts and accessories – – optionale bauteile und zubehörteile – – pièces optionnelles et accessoires – – pezzi opzionali e accessori – part # • nummer numéro • codice description beschreibung description descrizione pkz1039 hook and loop set (5): ultra micros parkzone: klettband set ul...

  • Page 20

    69 pappy boyington decal application – dekoraufkleber – – application des décalcomanies – applicazione decalcomanie – optional 1 opzione 1.

  • Page 21

    70 lt.Jg. Kepford lt.Jg. Kepford ira kepford optional 1 opzione 1 decal application – dekoraufkleber – – application des décalcomanies – applicazione decalcomanie –.

  • Page 22

    © 2014 horizon hobby, llc. E-fl ite, as3x, blade, celectra, umx, dsm, dsm2, dsmx, modelmatch, bind-n-fly, the bind-n-fly logo and the horizon hobby logo are trademarks or registered trademarks of horizon hobby, llc. The spektrum trademark is used with permission of bachmann industries, inc. Futaba is...