- DL manuals
- E-FLITE
- Toy
- UMX Spacewalker
- Instruction Manual
E-FLITE UMX Spacewalker Instruction Manual
Summary of UMX Spacewalker
Page 1
Instruction manual bedienungsanleitung manuel d’utilisation manuale di istruzioni umx ™ spacewalker.
Page 2
2 en warning: read the entire instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This is a sophisticated hobby product. It must be operated ...
Page 3: Table of Contents
3 en to register your product online, go to www.E-fl iterc.Com 11.6 in (295mm) 16.5 in (418mm) weight: 0.78 oz (22 g) wing area: 45.3 in 2 (292 dm 2) table of contents specifi cations installed installed 6mm brushed motor installed installed dsm2 ® /dsmx ® receiver/esc installed installed (2) servos o...
Page 4: Prefl Ight Checklist
4 en 1. Charge fl ight battery. 2. Install fl ight battery in aircraft (once it has been fully charged). 3. Bind aircraft to transmitter. (bnf only) 4. Make sure linkages move freely. 5. Perform control direction test with transmitter. 6. Set dual rates and expos. 7. Adjust center of gravity. 8. Perfo...
Page 5: Battery Charging
5 en your aircraft comes with a 1s 3.7v dc li-po battery charger and 1s 3.7v 70mah 14c li-po battery. Refer to the charging warnings. It is recommended to charge the battery pack while you are inspecting the aircraft. The fl ight battery will be required to confi rm proper aircraft operation in future...
Page 6
6 en binding is the process of programming the receiver to recognize the guid (globally unique identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen spektrum ™ dsm ® technology equipped aircraft transmitter to the receiver for proper operation. For a list of compatible ds...
Page 7: Transmitter Control
7 en the e-fl ite ® 4-channel dsm2/dsmx transmitter features digital trim buttons on all controls to make fi ne adjustments. The digital trims are used to fi ne-tune the model’s fl ight path when in fl ight. Before the fi rst fl ight, center the control surfaces mechanically (see control centering). When p...
Page 8
8 en flight battery installation and esc arming arming the esc also occurs after binding as previously described, but subsequent connection of a fl ight battery requires the following steps. It is normal for linear servos to make noise. Noise is not an indication of a faulty servo. Caution: always ke...
Page 9: Control Direction Test
9 en bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure aircraft control surfaces move correctly. Always keep throttle at the low position during testing. Down elevator right rudder left rudder up elevator control direction test before the ...
Page 10: Control Horn Settings
10 en control horn settings the table to the right shows the factory settings for the control horns. Fly the aircraft at factory settings before making changes. After fl ying, you may choose to adjust the linkage positions for the desired control response. Caution: when these are incorrectly connecte...
Page 11: Flying Tips and Repairs
11 en we recommend fl ying your aircraft inside a large gymnasium. We do not recommend fl ying the aircraft outdoors unless the conditions are absolutely calm. The aircraft is extremely light and can be easily blown away. Takeoff place the aircraft in position for takeoff (facing into the wind if fl yi...
Page 12: Power Components Service
12 en power components service 110 x 60 caution: do not handle propeller parts while the fl ight battery is connected. Personal injury could result. Disassembly 1. Disconnect the battery from the esc/receiver. 2. Carefully cut the tape and/or decals on the side of the fuselage to remove the top of th...
Page 13: Troubleshooting Guide
13 en problem possible cause solution aircraft will not respond to throttle but responds to other controls throttle stick and/or throttle trim too high reset controls with throttle stick and throttle trim at lowest setting throttle channel is reversed reverse throttle channel on transmitter motor di...
Page 14: Limited Warranty
14 en problem possible cause solution motor loses power damage to motor or power components do a check of motor and power components for damage (replace as needed) flight battery charge is too low fully recharge fl ight battery motor power quickly decreases and in- creases then motor loses power batt...
Page 15
15 en warranty and service information country of purchase horizon hobby phone number/email address address united states of america horizon service center (repairs and repair requests) servicecenter.Horizonhobby.Com/ requestform/ 4105 fieldstone rd champaign, illinois, 61822 usa horizon product sup...
Page 16: Declaration of Conformity
16 en declaration of conformity compliance information for the european union robert peak chief financial offi cer horizon hobby, llc instructions for disposal of weee by users in the european union this product must not be disposed of with other waste. Instead, it is the user’s responsibility to dis...
Page 17
61 replacement parts – ersatzteile – – pièces de rechange – pezzi di ricambio – part # • nummer numéro • codice description beschreibung description descrizione eflu2702 decal sheet: umx spacewalker dekorbogen: umx spacewalker planche de décal- comanies : umx spacewalker foglio con decal- comanie: u...
Page 18
62 – optional parts and accessories – – optionale bauteile und zubehörteile – – pièces optionnelles et accessoires – – pezzi opzionali e accessori – part # • nummer numéro • codice description beschreibung description descrizione pkz1039 hook and loop set (5): ultra micros parkzone: klettband set ul...
Page 19
? 2014 horizon hobby, llc. E-fl ite, celectra, umx, dsm, dsm2, dsmx, modelmatch, bind-n-fly, the bnf logo and the horizon hobby logo are trademarks or registered trademarks of horizon hobby, llc. The spektrum trademark is used with permission of bachmann industries, inc. Futaba is a registered tradem...