E&J Everest Lite Assembling Instructions

Everest Lite Assembly Instructions 

GF070000RevA07, January 2007

EVEREST LITE POWER WHEELCHAIR 

ASSEMBLY INSTRUCTIONS

It is possible for one person to assemble the Everest Lite Power Wheelchair, but assembly is 

best performed by two people, since some parts are heavy and hard to maneuver alone.

WARNING:  Read these instructions before assembling the Everest Lite.

WARNING:  GF Health Products, Inc. assumes no responsibility for any damage or injury 

caused by improper assembly or use of this product.

Unpack the carton

s

Caution:

NeverlifttheEverestLitebythefrontorrearcowl.

All components are in one carton. Remove the top packing material. Remove all components 

carefully and place them in the assembly area. Carefully position the base assembly on its 

wheels on the floor.

Assembly

1.  Pick up the battery pack by the strap, as shown at right, and 

install it in the base, with the arrow on the top of the battery 

pack pointing toward the front of the wheelchair. Ensurethat

thebatterypackisfirmlyseatedinthebasebeforeproceed-

ing.

s

Caution: Wheninstallingthebatterypack,pressthestrap

allthewaydown.

2.  Install the seat on the base as shown at right, while pulling the 

seat rotation lever to lock it in place. Ensure that the seat is 

locked into place and facing forward before continuing.

3.  The hand control is usually installed on the right arm, as 

shown at right, but may be installed on either arm. If you 

would like to install the hand control on the left arm, please 

see that adjustment in the owner's manual.

Install the hand control: Slide the extension into the bracket, 

as shown at right; loosen the knob first, if necessary. When 

the hand control extension is in the desired position, tighten 

the knob.

1

2

3