E-MOTO ELECTRIC BICYCLE Assembly Manual - Tool List
Getting Started...
Set out the carton paying attention to the “This Side Up” markings on the box.
Next, open both the inner and outer cartons. With the box open you should
remove the seat and any other loose accessories laying on top of the bike. With
the loose parts removed, lift the bike out of the carton and rest it on the floor.
Check the bottom of the box for any other remaining accessories. Accessories
included in the box are:
Battery Charger
•
Seat
•
Fenders
•
Owners Manual
•
Tool Kit
•
Basket, Basket Stay, Hardware Kit
•
Lock Chain
•
Warranty Registration Card
•
If anything is missing from the carton contact e-Moto immediately at 888-443-6686 for
a replacement.
Remove the Packing...
With the bike sitting on the ground, begin to carefully remove the packing
material on the bike-- and separate the parts bound to the bike with wire ties.
When removing the packing material use diagonal wire cutters instead of a knife
to prevent scratching of the frame.
Tool List
#1 and #2 Phillips Screwdriver
•
Metric Combination Wrenches, Size M8, M10, and
•
M15
Metric Hex (Allen) Wrench, Size M4, M5, M6
•
Diagonal Wire Cutters
•
Utility Knife
•
Note: Your e-Moto bicycle comes with a tool kit that contains most every tool
needed for assembly. Even though these tools are included, mechanics tools make
for an easier assembly and should be used if available.