E Rider Model 15 User Manual And Assembly Instructions - Remote:
On the left handlebar handle you will find three control buttons:
Top:
Red button operating the lights
Middle:
Slider switch to operate the indicators
Bottom:
Warning horn
When riding downhill you must have the
E
RIDER switched on even if
you are not using the throttle and even if the battery is not in the
bike. Otherwise the motor will generate enough electricity to damage
the controller beyond repair and this damage would not be covered by
the warranty.
Don't be concerned that the bike continues to drive when you release
the throttle. The controller continues to provide power to the motor for
six seconds after the throttle is released. You just need to brake to
reduce speed.
Your
E
RIDER will travel along flat roads at about 21 -23 kilometers
per hour. It will slow down as you go uphill and may increase speed a
little downhill. On steeper hills it will sometimes be necessary to assist
the motor by pedaling.
The degree of pedaling required depends on the weight of the rider as
well as other factors such as the amount of charge in the battery. On a
full charge your
E
RIDER has a range of approximately one and a half
riding hours, but again this will depend on many factors such as
terrain, temperature and weight carried.
Remote:
Buttons from the right:
First: Set Alarm
Second: Switch Off
Third:
Bike Locator
Fourth: Start (Press twice)