1. DL manuals
  2. E Rider
  3. Scooter
  4. RONDO
  5. User Manual

E Rider RONDO User Manual

Summary of RONDO

  • Page 1

    E rider rondo user manual and assembly instructions congratulations, once again, on buying an e rider rondo!!!! User manual we are sure you will be excited by the delivery of your brand new bike and you will be eager to start using your e rider as soon as possible. However you will need to be a litt...

  • Page 2: General Usage:

    Secondly, during the time your e rider has been in transport and storage, its battery will have lost some charge. Before using the bike you must put the battery on charge. Plug the charger to a power socket and you should get a green light on the transformer. Attach the charger to the battery and th...

  • Page 3: Operation:

    To charge the bike unlock the seat and remove the internal plug from the underside of the battery and plug in the charger. After charging, replace the battery in the bike making sure you plug it in once again and lock the battery in place. Please do not use any other charger than the one supplied wi...

  • Page 4

    The bike can now be started using either the ignition key or the remote control. To switch on the bike with the key, locate the power key socket below and to the right of the handlebars. Select the ignition key. Insert the key and turn to the 'on' position. The information display will light up and ...

  • Page 5

    On the left handlebar handle you will find three control buttons: top: high beam/low beam middle: slider switch to operate the indicators bottom: warning horn on the right hand handlebar you have the lights switch and hazard warning switch.

  • Page 6: Assembly Instructions

    When riding downhill you must have the rondo switched on even if you are not using the throttle and even if the battery is not in the bike. Otherwise the motor will generate enough electricity to damage the controller beyond repair and this damage would not be covered by the warranty. The rondo will...

  • Page 7

    Carefully unpack the bike and put it on its centre stand. Inside the small box you will find the charger, pedals and a tool kit containing the tools necessary to complete the assembly. There is another box which contains the wing mirrors. Remove the front axle. Please ensure you do not operate the b...

  • Page 8

    Next fit the front mudguard using the four bolts on the forks insert the brake disk on the front wheel between the brake calipers and re-fit the front axle. As you look at the picture below the correct order is right fork/large spacer/wheel/small spacer/left fork tighten the axle using the spanners ...

  • Page 9

    Fit the pedals. Please note that one will screw on clockwise and the other anti-clockwise. You will see the speed restrictor cable hanging down and this should be tucked up inside the frame. Please do not separate the cable as this may allow the bike to travel faster than the legal limit. That's it!...