E Star HUBBLE-11 User Manual - page 5
5
FLIGHT SETTING AND ADJUSTMENTS
AUTOMATIC CALIBRATION: (11)
ADJUSTING OF THE TRIM (FINE TUNING) (10)
SPEED CONTROL
Practice simulation before actual flying
1. Please practice with the RCU joysticks and buttons until you will get used to the Remote Controller.
2. Put the aircraft in the open space, 2-3 meters in front of you, the red lights mark the front of the drone.
3. Exercise the joystick functions without turning on the RCU, then practice the hovering function and adjusting
the trim of the drone first, see instructions further. Hovering means keeping the drone in the mid-air, fixed
position.
It is recommended to set the drone into “calibration” mode before flying, so all settings will be restored as factory
settings with automatic fine-tuning.
Procedure : place the drone on the flat horizontal surface, turn on the drone and proceed binding , then
simultaneously move the left and right joystick to the lower left corner position and hold for few seconds until the
lights of the drone will stop flashing. The drone is ready to operate now.
When starting to hover at the low level above the ground
the drone may move slightly in either direction – left or right,
forward – backwards, or turn left - right even if the joysticks are
in central position. If this is noticed, it is required to proceed
fine tuning by the help of fine tuning buttons on the RCU
FUNCTIONS. There are 2 buttons with 2 positions for fine tuning each direction, please check the picture of RCU.
Press these buttons up to several times (each time you will hear the beep) for forward – backward, left –right and
turning right – left fine tuning. Please check the illustrations for the trim adjustments.
The drone has 2 speed levels which can be used according to the practice level of the Pilot.
After first turning on the default speed level 1 is 40%. This is the recommended level for
novice Pilot. When you press the speed button, you will hear two beeps – the drone
switches to the second speed level -100%. Further press sets back to Level 1.
360 degree FLIPPING FUNCTION (9)
When you are used to basic operation, you can do some awesome tricks and stunts!
First, fly the drone to the height not less than 2-3 meters, press FLIP button (press down RIGHT joystick) , then
push the right joystick in any desired direction to make 360 degree flip.