Summary of MATRIX 50
Page 1
H9900-5va0-0000 matix 50 matrix 50 copyright ©2008-2009 eton america, all rights reserved..
Page 2: Important Notices
Dear customer, important notices page 1 we at eton wish you many years of pleasurable driving. Eton america, llc. It was engineered and designed to provide a reliable form of economic transportation for your life style. This manual was designed to provide you with the basic understanding of the stru...
Page 3: Table of Contents
Table of contents vehicle identification number location 3 controls, switches, and feature locations 3 control feature operations engine stop switch 4 turn signal switch 4 horn button 4 manual choke lever 4 headlight control switch 4 ignition control switch 5 instrument panel 5 throttle control 5 th...
Page 4
Controls, switches & feature locations locations of controls and features vehicle identification numbers engine serial number is located on the left-hand side of the engine on the crankcase housing. Vehicle identification number (vin) is located on the frame behind the foot guard and is covered by a...
Page 5: Head Light Control Switch
Right handlebar control head light control switch for safety, the head light system of this unit was designed to be illuminated at all times while the unit is running. The intensity of the light is changed by using the head light control switch located on the right-hand handlebar. It is a three posi...
Page 6: Instrument Cluster
The instrument cluster provides you with operating conditions of your vehicle. To the left is the fuel gauge which indicates the fuel level in the fuel tank. When the needle reaches the red zone on the gauge, you are running iow on fuel and the tank should be refilled. This gauge is controlled by a ...
Page 7: Throttle Cable Adjustment
To increase the throttle, twist the handle grip in a counter clockwise rotation. To decrease throttle, twist the hand grip in a clockwise rotation or release your pressure and allow the throttle to return on it own. The throttle cable should be adjusted so there is 1 5-10mm, ( / 4 ") free travel of ...
Page 8: Hydraulic Fluid Reservoir
1 fill the reservoir to / 8 " from top with dot-3 sae- j1703 grade brake fluid. Refold the cover gasket as shown in picture and replace cover and bolts. Caution: do not allow dirt to fall into the reservoir. Remove the reservoir cover by removing the two cover bolts. Fill the reservoir to 1/8" from ...
Page 9: Purging The Brake Lines
Purging the brake lines clockwise. Squeeze the brake lever to expel air from the system. While holding the brake lever, close the bleeder valve. Repeat steps 2 through 4 until the brake fluid coming from the bleeder valve is a solid stream without any air, then close the valve and replace rubber pro...
Page 10: Inline Fuel Filter
Your vehicle is equipped with an inline fuel filter to prevent dirt and debris from entering the carburetor and engine. The filter should be replaced every 10,000 miles or each year of operation. Replacement and fuel line inspection should be preformed by an authorized eton dealer only. Never refuel...
Page 11: Tires and Wheels
Cover. The oil tank capacity is 1.1 liters, 1.2qt. Fill the tank with high quality jaso fc grade 2 cycle injector engine oil. Using lower grade oil can cause exhaust smoke and result in damage to your engine. Your first tank of fuel should be a pre-mix fuel with a 50:1 fuel to oil ratio. This will i...
Page 12: Spark Plug
Replace the spark plug every 10,000 miles or if the plug should become damaged or fouled. We recommend that you use ngk - bpr7hs. Disconnect spark plug wire. Clean dirt from around spark plug base with brush or air. (caution: do not allow dirt or foreign material to enter the engine) remove spark pl...
Page 13: C.V.T. Filter
When reinstalling the battery, be sure to connect the red cable to the positive (+) terminal and the black cable to the negative (-) terminal. The battery should be replaced every three years or when it no longer holds a charge. Do not expose the battery, for extended periods of time, to freezing te...
Page 14: Beamer Break-In
Beamer break-in procedure your beamer requires a break-in period just as with all other internal combustion engines. This period allows the engine parts to seat and wear properly without undue strain which can cause premature failure. 1. For the first 1000 miles of operation do not operate your vehi...
Page 15: Driving Your
Driving your scooter in slippery conditions such as on snow or ice covered roads. When going downhill, release the throttle grip and use your brakes to control your speed. After washing your vehicle your brake shoe and pad may have become wet and will reduce the braking force until they have had a c...
Page 16: Specifications
Page 15 sw 18mm (manual choke) 1 1 back out / 2 - 1 / 4 turns idle 1700-1900rpm 12v-4ah/5ah - gtx5l-bs unleaded gasoline 89 octane high grade synthetic 2 cycle injector oil 1.1 ligers / 1.2qts sae 80/90 weight 100cc / 3.4oz bpr7hs w22frp-u ql82yc 0.6-0.7mm / 0.023" 150kg / 330lbs. #80 #17.5 6.5liter...
Page 17: Maintenance Schedule
Maintenance schedule i = inspect, clean, adjust, lubricate or replace as needed c= clean l = lubricate r = replace first week every 30 days every year fuel lines throttle operation air filter fuel filter spark plug drive chain brake shoes brake system brake fluid wheels steering system suspension sy...
Page 18: Iri
W iri ng d ia gr am page 17 copyright ©2008-2009 eton america, all rights reserved..
Page 19
Nhtsa safety notice if you believe that your vehicle has a defect which could cause crash, injury, or death, you should immediately contact the national highway traffic safety administration (nhtsa) in addition to notifying eton america, llc. If nhtsa receives similar complaints, it may open an inve...
Page 20: Eton America, Llc.
Eton america, llc. Limited vehicle warranty eton america warrants all new eton vehicles sold by authorized eton dealers to be free from defects in materials and workmanship, subject to the following exclusions and limitations. New vehicles sold by an authorized dealer to original retail consumers ar...
Page 21: Eton America, Llc.
This warranty is valid at any authorized eton dealer in the united states only. In the event you experience any problem obtaining prompt service, contact eton america, customer service department for assistance. Always consult first with your selling dealer and or service personnel for assistance wi...
Page 22: Eton America, Llc.
Scooter/moped limited warranty federal emmission control systems eton america llc warrants each new scooter/moped vehicle that includes as standard equipment a taillight and a stoplight; c) is designed, built and equipped so as to conform at the time of initial retail purchase with all applicable re...
Page 23: Eton America, Llc.
Scooter/moped limited warranty federal emmission control systems 7) limitations. This emission control system warranty shall not cover any of the following: a) repairs or replacement required as a result of (i) accident, (ii) misuse or neglect, (iii) lack of reasonable and proper maintenance, (iv) r...
Page 24
H9900-5va0-0000 copyright ©2008-2009 eton america, all rights reserved..