Summary of EW-1200
Page 1
Ew-1200 owners manual electricw heelstore.Com.
Page 2
The contents of this manual must be carefully read and instructions followed before you ride your index of contents Ⅰ、general assembly instructions. Ⅱ、recommended inspection before riding. Ⅲ、charging instructions. Ⅳ、maintenance. Ⅴ、simple troubleshooting. Ⅵ、warranty. One riverway, suite 1700, houston...
Page 3
Ⅰ、 general assembly instructions please allow yourself one hour for unpacking, assembly & checking ew1200 remove all packaging remove all materials and set parts aside for assembly. Pedals and charger front mudguard saddle.
Page 4
Minimal assembly is required for your ew1200. However please follow the guidelines below for correct assembly. Tools required- 15mm pedal spanner, 6 mm hex key, 8 mm hex key, 8 &10mm spanner. Install front mud guard set up please install the front mud guard before you install the front wheel. Tighte...
Page 5
The front wheel is a quick release type. The quick release locking lever must be set squarely in line with the front fork and firmly tightened to ensure safety. Please check before each ride. • the handle bar assembly may need some small adjustment for the alignment of the headset to the front wheel...
Page 6
Place a small amount of grease on the thread before installing. Install pedals and tighten crank. Ensure you clearly identify right and left pedals by the r or l stamped on the end of the pedal shaft. Right pedal screws in clockwise. Identification is very important because the left pedal has a reve...
Page 7
Front brake set up front caliper v-type quick release brake. Loosen the 6 mm allen screw on the cable holder (pic 1) and pass the cable through loosely. Close the caliper manually and locate the metal cable guide in the caliper holder (pic 2). Now pull the slack cable through the cable holder and ad...
Page 8: Ⅲ、charging
Ensure you are fully familiar with the operation of the bike. Ensure you know how the pedal assist and power button works. Ensure the saddle is adjusted to suit your leg length. Ensure people/children are clear of moving wheels etc. Safety ride safely and always wear protective gear including knee p...
Page 9
In position with ignition key. Never remove battery from the housing enclosure – this will void your warranty. Always have the charger switched off before connecting to the battery. Connect and turn on. The led will turn red when charging then green when fully charged. It is recommended to switch of...
Page 10: Ⅳ、maintenance
Ⅳ、maintenance 1. Wipe the bike with a dry cloth, or neutral detergent. 2. Use lubricating oil sparingly for moving parts. 3. Wipe the plastic and painted parts with a cloth. 4. Increase the frequency of lubricating with light oil in wet and humid areas see as below (recommend 30sae lubricating oil)....
Page 11: V、simple Troubleshooting
• it is recommended you have a bicycle workshop assist you with the adjustment of the gears. Gear adjustments • cable tension must be checked to ensure there is no slack in cable when in highest (fastest gear). Failure to do this will result in poor gear changes. • tension of cable can be adjusted o...
Page 12: Ⅵ. Warranty
Ⅵ. Warranty 1. This warranty takes effect after dealers confirm. 2. Warranty period items warranty period parts covered by warranty normal parts 180 days after purchase all the parts but excluding wearing parts. (tires, brake pads etc). Battery 90 days after purchase lithium battery position of seri...