E-Z UP Escort Owner's Manual - page 2
W
HAT
'
S
I
N
T
HE
B
OX
• Escort
®
Frame
• Roller Bag
• Polyester Top
• 4 Piece Stake Kit
4.
Release the Pull Pin at each
corner by first lifting fabric top corner.
With one hand, push up on truss near
slider to remove the weight of the
shelter from Pull Pin. Pull the Pull Pin
out to release the Pull Pin slider.
5.
With partner on opposite side,
grasp top and bottom of diamond-
shaped area of trusses and slightly lift
up. Shake shelter slightly, pulling
hands apart, while stepping towards
partner until shelter is 3/4 closed.
6.
Grasp adjacent outer legs and
push shelter together until fully closed.
Be careful not to pinch fingers!
Store shelter in roller bag. (See Roller
Bag Instruction enclosed within your
Warranty Kit).
1.
Place your E-Z UP
®
frame in
the center of area to be sheltered.
With partner standing on opposite
side of frame, the tallest trusses
should be in front of you. Grasping
two outer legs, slightly lift frame off
ground and step backwards,
stopping at full arms' length.
2.
Unfold the top and drape over
partially opened frame. Place the
peaked side of the top’s valance on the
side of the frame with the tallest
trusses. Match hook and loop strips on
the top with the strips located just
below the corner caps on each leg (see
photo). Push the strips firmly together
1.
Grasp the top and bottom of
diamond-shaped area of trusses.
Slightly lift shelter up and push
hands together while stepping
backwards until shelter is fully
opened.
Be careful not to pinch
fingers or pull backwards too
hard as trusses will bend.
2.
Check Pull Pin at each corner to
make sure Pull Pin has engaged. If Pull
Pin slider is not engaged push slider
with one hand while pushing down on
the top of the leg with the other hand.
Pull Pin will engage in hole. Repeat step
on remaining legs.
H
OW
T
O
T
AKE
D
OWN
4.
Lift two adjacent outer legs and slide out
inner legs until the snap button locks into place.
2.
Lower remaining legs, by
telescoping inner legs into outer legs.
5.
Lift up the remaining two outer legs and
slide inner legs until snap button locks.
Use stakes to secure in windy conditions.
3.
Important:
Remove the
support arms by lifting the mounting
brackets from between the two
washers and let it hang freely from
the peak truss.
3.
Support arms should be engaged
by seating the mounting brackets firmly
between the two sidewall washers.
Note: Size 12’ x 14’ model will have
2 sets of support arms.
1.
With a partner, lift adjacent outer
legs up 1”, depress snap button and
telescope inner legs into outer legs.
Pull Pin
Please read each step before you attempt to set up.
Save these instructions for future reference.
F
IRST
T
IME
T
OP
A
TTACHMENT
H
OW
T
O
S
ET
U
P
First: Repeat Step 1, in ‘First Time Top Attachment’
OM_911_1214 Escort 2010.qxd 10/26/10 9:25 AM Page 2