E3 Cycling F11C User Manual - page 4
Tech Support 1(800)553-8324
0408_4
Made in China
STEP 8
Wrap the excess sensor cable around the front brake cable housing, securing with electrical tape as
necessary. When fi nished, enough cable slack should remain for the computer mounting bracket to reach
the handlebar. Check to make sure that all excess sensor cable is either taped down or wrapped around the
brake cable housing so that nothing can snag it during a ride.
BRACKET INSTALLATION
Remove the backing from the small, adhesive rubber pad and apply the pad to the underside of the
mounting bracket. Use two zip-ties to attach the bracket to the handlebar as shown in Figure 4. Once
the bracket is securely installed, trim the excess zip-tie ends with scissors.
COMPUTER HEAD INSTALLATION
Place the computer head in the bracket and twist the head clockwise until you hear a ‘CLICK’, indicating
that the unit is locked in the bracket. See Figure 5. To remove the computer head, twist the head
counterclockwise and then lift it out of the bracket.
TEST OF INSTALLATION
Once installation is complete, test the unit to make sure everything is adjusted and working properly.
STEP 1
Install the computer head in the handlebar bracket and press the RIGHT button to advance to the Cadence
(C) display screen.
STEP 2
Lift the rear of the bicycle and turn the cranks. The computer should register a speed reading and cadence
reading within 1-2 seconds. If it does not, check the alignment of the speed and cadence magnets with the
sensors. Make sure the space between the magnets and sensors is 3mm or less. Adjust as necessary and
re-test.
Select Wheel Size
When switching your computer between bikes with diff erent wheel sizes, don’t forget to select the
appropriate wheel size setting (
1
or
2
) for each bike. In the Average Speed display screen (AVG), press and
hold the RIGHT button for three seconds to change between wheel size
1
and wheel size
2
.
Using the Stopwatch
STEP 1
In the Stopwatch display screen (STP), press the LEFT button to start the Stopwatch. Press the LEFT button
again to stop the Stopwatch. While the Stopwatch is running, the computer will calculate an estimate of
Calories burned and Fat burned during the timed session.
STEP 2
When the Stopwatch is stopped, Stopwatch time, Calories burned (C) and Fat burned (Lb or Kg) will be
displayed in a continuous loop. Remember that Calories burned and Fat burned are only calculated while
the Stopwatch is running.
STEP 3
To reset the Stopwatch, advance to the Stopwatch display screen (STP) and press and hold both the LEFT and RIGHT buttons for four seconds.
Reset Display Screens
The ATM, DST, AVS and MAX display screens are reset simultaneously. In the Automatic Ride Timer display screen (ATM), press and hold both the
LEFT and RIGHT buttons for four seconds to reset the data in all four screens.
The Stopwatch is reset independently. In the Stopwatch display screen (STP), press and hold both the LEFT and RIGHT buttons for four seconds
to reset the Stopwatch.
Maximum Speed can also be reset independently. In the Maximum Speed display screen (MAX), press and hold both the LEFT and RIGHT buttons
for four seconds to reset Maximum Speed.
To reset ALL display screens and ALL programmed settings (including Clock, Odometer, wheel size settings and weight), depress the reset button
on the underside of the computer head. See Figure 6.
4
LOCK
UNLOCK
5
6
3
cadence
1-3mm
1-3mm
speed