Eads Telecom Connexity M350 User Manual - Réglages
Chaque réglage est confirmé
par un bref signal sonore.
Vous pouvez modifier le volume
et la mélodie de la sonnerie.
• Décrochez le combiné ou haut-parleur.
• Appuyez sur la touche programmation
et ensuite sur la touche 1.
Vous entendez la mélodie actuelle.
Réglez le volume sonore (inhibition,
faible à fort).
Réglez la mélodie (1 à 7).
• Appuyez à nouveau sur la touche
de programmation pour valider.
Vous pouvez également régler
la sonnerie pendant que le téléphone
sonne. Sans décrocher le combiné,
réglez le volume de la sonnerie à
l'aide de la touche plus/moins et
la mélodie à l'aide des touches 1 à 7.
Nota : si vous sélectionnez le niveau 0,
la sonnerie est coupée. L’afficheur
présente en permanence le symbole.
Attention : Si le poste n’est pas
alimenté par la pile, l’afficheur est
inactif pour signaler l’arrivée
d’un appel : l’inhibition sonnerie est
signalée par un bip lors de la prise
de ligne.
L’affichage de la date et de l’heure
s’effectue par appui sur la touche
Correction
L’affichage de la date et de l’heure
s’active après réception d’un appel
avec présentation du numéro (CLIP)
par votre Pbx ou votre opérateur*.
*si cette information est transmise
Each setting is confirmed
by a short audible signal.
You can modify the volume
and the melody of the ringing tone.
• Pick up the handset.
• Press the programming key
and then press key 1.
You can hear the current melody.
Adjust the volume (disabled, low to
high).
Select the melody (1 to 7).
• Press the programming key again
to validate.
You can also adjust the ringing
tone while the phone is ringing.
Without picking up the handset,
adjust the volume of the ringing
tone using the plus/minus key
and select the melody using
keys 1 to 7.
NB: if you select level 0, ringing is
disabled. The display permanently
shows the symbol.
Caution: If the telephone is not
powered by the battery, the display is
inactive to signal an incoming call.
Ringing disabled is signalled by a beep
when the talk key is pressed.
The date and time are displayed by
pressing the Correct key
The date and time display is activated
after a call is received with caller ID
(CLIP) by your Pbx or operator*.
*if this information is transmitted
> 12 <
>>
Réglages
>>
>>
Settings
>>
Régler la sonnerie
>
Adjusting the ringing tone
>
Date et Heure
>
Date and Time
>
P
1
1
7
P
/