Eager LED LVP603S User Manual - page 20
LVP603S User’s Manual
---------------------------------------------------------------------------------------------------
LED VIDEO PROCESSOR
20
LVP603S will capture. As shown in Figure 5, the the vertical start point
of the four sets of LVP603S are set as below respectively:
1# LVP603S Vert_In_Str = 0
2# LVP603S Vert_In_Str = 0
3# LVP603S Vert_In_Str = 540
4# LVP603S Vert_In_Str = 540
8. Audio configurations
LVP603S supports
5
-channel stereo audio switch. Of which, 3
channels are DP, HDMI and SDI audios, the other 2 channels are
AD1, AD2 external input audio. AD1 and AD2 can be mapped to the
anyone of all video inputs, and will be switched synchronous to the
selection of video input signals.
If HDMI ( DP/ SDI) is external input audio, when switched to
another signals, you should choose the external audio signal input or
HDMI ( DP/SDI) itself audio signal.
Item 25: “Audio1 Config ”
Press “ ←” or “ →” to select 1 channel signal from all video input
signals , map AD1 external input as audio input signals to the video
signals in this channel, then press “ Enter” to save the settings.
Item 26: “Audio2 Config ”
Press “ ←” or “ →” to select 1 channel signal from all video input
signals, map AD2 external input as audio input signals to the video
signals in this channel, then press “ Enter” to save the settings.
Notes: AD1, AD2 can’t be mapped to the video input signals in
the same channel.
9. Exit setup
Item 27: “Exit Setup ”
Press “↑” to move to the last item: “ Exit setup ”, then press “ ←”
or “ →” to select “ YES ”, then press “ Enter” to exit setup mode.
If you press “ Setup” key while in any setup mode, the system will
skip to the No.27 item.