1. DL manuals
  2. Eagle
  3. Sonar
  4. CUDA 240I S
  5. Additional Instructions

Eagle CUDA 240I S Additional Instructions - Menu

Summary of CUDA 240I S

  • Page 1

    1 pub. 988-0152-081 addendum i additional instructions for eagle cuda 240i s/gps your sonar/gps unit, the cuda 240i, functions exactly like the cuda 240 described in the manual provided (part 988-0152-012). In addition, the cuda 240i contains a communications port for nmea 0183 output. The instructi...

  • Page 2: Wiring Diagram "a"

    2 a few other radio brands (and other electronic devices) that meet the nmea 0183 standard won't need these adapters and you will have to remove the resistor and diode to make those work. This is wiring diagram b , which is described on page 4. Consult your other device's owner’s manual, then read t...

  • Page 3: Ground/shield Or Nmea –

    3 twist the exposed wires together as shown in the following figures. If you're using a uniden or similar radio, connect the radio's nmea wire to the cuda 240i data cable's yellow wire, and the radio's ground/shield wire to the cuda 240i data cable's black shield wire. If you're using another radio ...

  • Page 4: Wiring Diagram "b"

    4 after taping the wire ends individually, wrap the entire connection with electrical tape as shown. This will help protect from moisture and prevent the wires from breaking contact. Wiring diagram "b" if your vhf radio or other device requires true rs-232, you will need to remove the diode and resi...

  • Page 5: (–) Receive Or Ground

    5 after you've removed the adapter segment, use wire pliers to expose the ends of the five remaining wires in the cable. Cut off the black, blue and white wires, then seal their ends with electrical tape. After removing the adapter segment, prepare to connect by removing and taping off unneeded wire...

  • Page 6: Menu

    6 communications port configuration now that you have the devices connected, use the com port command in the system setup menu to make them communicate. This command opens a menu that allows you to configure the communications port. Menus for changing com port settings. If you need additional assist...

  • Page 8: Exit

    8 • gga transmits time, position and fix related data. • apb transmits autopilot information. • rmc and rmb transmits navigation information messages. • gsa and gsv transmits fix mode, dop values and satellites in view information. • dbt transmits the depth below the transducer. • dpt transmits the ...