Eagle Power 315P Operation And Parts Manual

Manual is about: WET/DRY VACUUMS

Summary of 315P

  • Page 1

    Important! Read this manual prior to use. Models: 315p 415p 429p 415s 415st 415plt 429st operations and parts manual wet/dry vacuums polyethylene, polypropylene & steel.

  • Page 2: Table Of Contents

    Table of contents page no. Important safety instructions . . . . . . . . . . . . . . . . . . . . . .1-3 vacuum and accessories . . . . . . . . . . . . . . . . . . . . . . . . . .4 operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 wiring diagram . . . . . . . . . ...

  • Page 3: Warning

    Important safety instructions when using an electrical appliance, basic precaution must always be followed, including the following: read all instructions before using this machine. This machine is for commercial use. Warning danger: failure to read and observe all danger statements could result in ...

  • Page 4: Save These  Instructions

    Danger: electrocution could occur if maintenance and repairs are performed on a unit that is not properly disconnected from the power source. Disconnect the power supply before attempting any maintenance or service. Warning: operating a machine without observing all labels, decals, etc., could resul...

  • Page 5

    120 volt machine instructions for connection to the power supply and the electrical ground this machine must be connected to the electrical ground to protect the operator from electric shock. The machine has an approved power cord with three conductors and a plug with three terminals. Connect the pl...

  • Page 6

    Vacuum and accessories 4 a motor block b on/off switch c float: keeps liquid out of motor block d polyester filter: remove for use with liquids e hooks: secure motor block to tank f suction inlet g tank h 1-pc. Hose end, bent pvc i hose, 10-ft. X 1-1/2" flexible j 1-pc pvc wand (2) k adapter m dust ...

  • Page 7: Dual Switches

    5 this machine is a commercial vacuum designed for wet and dry pick-up. The dual vac motors can be run together or separately as the job requires. Dry soil can be vacuumed directly into the tank. To empty the tank of dry soil, remove the top and dump into trash receptacle. For wet pick-up, remove po...

  • Page 8

    6 (every six to twelve months): 1. Check filter for wear, replace dirt saturated filters that do not respond to normal cleaning. 2. Inspect gasket seals and replace those which have begun to leak. 3. Examine carbon motor brushes and commutator. Periodic maintenance the filter is accessed by lifting ...

  • Page 9

    7 carbon brush replacement 1. Disconnect power cord from power source. 2. To access the vac motor, remove the screws that attach the main cover to the head assembly and set the cover to one side. 3. Remove the motor cover by removing two screws. See figure 1 4. Remove the wire terminal from carbon b...

  • Page 10

    315 vacuum motor assembly no. Part num. Description qty. 1. S80326 switch, on/off 1 2. S81006 screw, 5 x 20 5 3. S81006 screw, 5 x 20 2 4. S80140 terminal block 1 5. S81006 screw, 5 x 20 4 6. S82992 handle, lift 1 7. S81152 1 8. S80138 strain relief, black 1 9. S81122 cord 1 10. S81006 screw, 5 x 20...

  • Page 11

    415 vacuum motor assembly no. Part num. Description qty. 1. S81006 screw, 5 x 20 6 2. S81150 cover, dome 1 3. S82992 handle 1 4. S81006 screw, 5 x 20 2 5. S80139 clamp, cord 1 6. S80138 strain relief 1 7. S81122 power cord, single motor 1 t82102005 power cord, dual motor 8. S81006 screw, 5 x 20 2 9....

  • Page 12

    10 415p tank assembly no. Part num. Description qty. S82615 complete tank 2 1. S82558 handle 1 2. S82637 tank 1 3. S81026 screw, 5x30 4 4. S82584 retainer, tank 1 5. S82846 gasket 1 6. S82593 deflector 1 7. S82652a adapter, hose 1 8. S81300 rivet, 5 x 24.5 4 9. S81847 clamp, tank 2 10. S81050 screw,...

  • Page 13

    415st tank assembly no. Part num. Description qty. 1. S82993 handle 2 2. S81847 clamp, tank 2 3. S81302 rivet, 5 x 19 4 4. S83629 screw, 5 x 25 4 5. S83883 washer 4 6. S83253 tank – steel 1 7. S81026 screw, 5 x 30 4 8. S82586 adapter, tank 1 9. S82846 gasket 1 10. S82593 deflector 1 11. S82583 adapt...

  • Page 14

    415s tank assembly no. Part num. Description qty. 1. S82993 handle 2 2. S81847 clamp, tank 2 3. S81302 rivet, 5 x 19 4 4. S83629 screw, 5 x 25 4 5. S83883 washer 4 6. S80476 tank 1 7. S81026 screw, 5 x 30 4 8. S82586 adapter, tank 1 9. S82846 gasket 1 10. S82593 deflector 11. S82583 adapter, hose 1 ...

  • Page 15

    415plt tank assembly no. Part num. Description qty. 1. S81847 clamp, tank 2 2. S81300 rivet, 5 x 24.5 4 3. S83773 tank 1 4. S81026 screw, 5 x 30 4 5. S82586 adapter, tank 1 6. S82846 gasket 1 7. S82593 deflector, tank 1 8. S82583 adapter, hose 1 9. S82594 button, hose 1 10. S82608 spring 1 11. S8377...

  • Page 16: Spare Parts

    Accessories s70042 front mounted squeegee, for all 415 models s72741 paper bag s82860 filter bag, standard for 315 model s82845 filter bag, standard for 415 model s82852* filter cartridge, paper, optional for 415 s76061* filter cartridge, washable paper, optional for 415 s82995* filter cartridge, he...

  • Page 17

    Please be sure to record this information. This information will be necessary for future warranty rclaims. Warranty policy limited warranty eagle power products (epp) warrants new cleaning equipment against defects in material and workmanship under normal use and service to the original purchaser as...