1. DL manuals
  2. Eagle Power
  3. Vacuum Cleaner
  4. Speed Vac
  5. Operation And Parts Manual

Eagle Power Speed Vac Operation And Parts Manual

Manual is about: 24” Battery Vacuum Sweeper

Summary of Speed Vac

  • Page 1

    Speed vac 24” battery vacuum sweeper operation and parts manual rev. A 4/2002.

  • Page 2

    General notes this guide has been edited for the consumer according to directive ce897392 and its ensuing amendments. Carefully read the notes contained in this guide since they provide important directions regarding the safety of assembling, use and maintenance. Each machine, in accordance with dir...

  • Page 3

    Condition of use consented uses the 24” battery vacuum sweeper is built for cleaning the ground in the following conditions of employment: a - environments: *both closed and opened. B - working surfaces: *level surfaces enough compact and not much irregular as: - ceramics - wood - marble - concrete ...

  • Page 4

    Unpacking and setup of the machine 1- remove the packing and make sure of the machine integrity. 2- before using the machine proceed in this way: 2.1 take from the waste hopper table b-1 the side broom – table a-20 2.2 unscrew the screw and washers table a-24 from the gearmotor table a-15. Insert th...

  • Page 5: Battery

    Main broom operating the switch (figure 1-2) the main broom table c- 14 starts to work reaching immediately the running speed. The lighting of a green led signals the regular operation. With the main broom working it is possible to operate: side broom operating the switch (figure 1-3) the side broom...

  • Page 6

    Ordinary maintenance maintenance and replacement of the main broom: a- cleaning: check periodically, according to the use of the machine, the wear conditions of the main broom table c-14.To carry out this operation, the following tools are needed: - heavy-duty gloves. - breathing mask. - scissors - ...

  • Page 7

    Maintenance and replacement of the filter: to carry out this procedure the following tools are needed: - heavy duty gloves. - breathing mask. A- cleaning / replacement: - withdraw the split pin table b- 11 from the hole of the pin table b -11 that hold the filter- support (table b- 10) at the machin...

  • Page 8

    Maintenance and replacement of the electronic circuit board: in case of non-operation of some electrical components, check out the integrity of the fuses: figure 2 - f2 in case of a non good operation of the function of battery charging, check out the integrity of the fuses: figure 2 - f1 figure 3 -...

  • Page 11

    Table a-spare parts pos. Code description 1 p 030 33110 cover 2 3 017 e400b wired commands console (switches box) 3 4 100 33201 handle 4 k 999 00001 handle adjusting kit 5 k 999 00002 handle pivot kit 6 4 350 33200 battery strap 7 8 600 33030 gel sealed battery 12v 42ah 8 3 015 a400b vacuum fan unit...

  • Page 12

    Table b - spare parts - pos. Code description 1 4 018 a400b electronics control board 2 e fus 01003 fuse 1.5 a 3 4 018 33011 transformer 4 s cav 01010 coiled cable 5 k 999 00007 rear wheel kit 6 4 310 33140 gasket 7 8 119 33100 clamp lever 8 e fus 02002 fuse 30 a 9 4 021 33100 hopper 10 e fus 01001 ...

  • Page 13

    Table c - spare parts - pos. Code description 1 4 202 04444 side broom adjustment label 2 k 999 00009 left cam kit 3 4 320 33201 side flap rubber 4 4 240 33250 main broom short spacer 5 4 260 33170 main broom pulley hub 6 4 270 33151 main broom shaft 7 4 340 33151 main broom 8 4 260 33160 main broom...

  • Page 14

    Please be sure to record this information. This information will be necessary for future warranty claims. Serial number: date purchased: model number: eagle power products sales and service provided by: 1174 northland drive mendota heights, mn 55120 651.686.5399 fax 651.686.5695 www.Eaglepower.Com w...