Hvlp s sppray guun ( high volume low pressure) operating instructions thank you for purchasing the earlex hvlp spray gun. This can only be used with an earlex combivac or combi power vac so if you don’t have one of these please do not proceed with using the gun. This is a highly versatile spray gun ...
Safety operating instructions 2 please read before use never under any circumstances aim the nozzle at another person or animal. In the event of injury occuring seek expert medical advice immediately. The spray gun must only be used with paints and solvents that have a suitable flash point for spray...
3 parts list key discription part no. No. 01. Hose connector wd0194 02. Fluid needle assembly wd0198 03. Spring wd0199 04. Fluid adjusting screw wd0200 05. Gun body wd0201 06. Air flow plate wd0202 07. Fluid tip wd0203 08. Nozzle wd0204 09. Adjustment ring wd0205 10. Fluid tube wd0206 11. Container ...
Important – selecting paint this is a highly versatile spray gun that can be used with several different spray mediums including varnishes, wood preservatives, enamels, oil and water based paints and cellulose. However some materials cannot be sprayed so please check the manufacturer’s recom- mendat...
Dip the viscosity cup into the material and fill up. Time how long it takes for the viscosity cup to empty (fig 1). Using the above chart (or manufactur- er’s instructions) as a guide determine if the material requires further thinning, if so then thin accordingly. Operation fill the paint container...
6 paint volume the volume of paint sprayed is easily adjustable.(fig.4) completely close adjustment screw (4) by turning this clockwise as far as it will go. Whilst pulling the trigger, begin turn- ing the adjustment screw anti-clockwise until the volume of paint you require is obtained. If the pain...
4. When spraying large areas or objects, it is best to use a criss-cross pattern, either from left to right then up or down or vice-versa. This will ensure maximum coverage (fig. 6). 5. Avoid stopping and starting when spraying as this can lead to too much or not enough material on a surface. 6. To ...
8 trouble shooting problem cause action required the paint drips onto item paint too diluted add undiluted material being painted fluid adjustment screw reduce the paint flow by adjusting screw (4) moving too slowly increase speed of application gun trigger being held release trigger earlier for too...
9 other products from earlex combivac accessories wdacc2 - deluxe floor head with hard floor, brush and squeegee attachments. Wider head for greater coverage, suitable for carpets and faster pickup of debris and spills. Wdacc10 - pack of three spare foam filters. Wdacc11 - pack of three spare paper ...
10 wd0215 02/00 earlex ltd., earlex house, moorfield road, slyfield industrial estate, guildford, surrey, gu1 1ru. Tel: 01483 - 454666. Fax: 01483 - 454548 e.Mail: enquires@earlex.Co.Uk website: www.Earlex.Co.Uk final.Qxd 22/02/00 11:05 page 10
