Earlex sprayport hv7000/230 ® operating instructions thank you for purchasing the earlex sprayport ® . This is a highly versatile spray kit and can be used for a variety of applications. Before use - please read the safety & operating instructions. Please retain for future reference to register your...
• caution: to reduce the risk of electric shock or injury, do not use in the rain. Store indoors. • the substances used with this spray gun (paint, thinners, etc) may contain hazardous, harmful, explosive or corrosive materials. Always comply with the safety instructions issued with this product and...
1 2 3 4 5 6 7 8 9 10 11 12 7 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 fig.1 optional extras: nozzles & fluid tips of different sizes can be obtained as sets under the following accessory numbers. Please call our helpline to order these on +44 (0) 1483 454666. 1.0mm dia fluid tip, needle & seal h...
Turbine unit & carrier stand parts drawings power in (iec connector) circuit breaker 1 2 3 5 6 7 4 mains switch (230v) for information on all spare parts for this unit please contact earlex ltd on our helpline no: +44 (0) 1483 454666 volts 220-240v frequency 50-60hz wattage 1100w turbine stages 3 le...
The earlex sprayport ® is an industrially rated, portable, paint spraying system and is intended for use by professionals. Hvlp stands for high volume, low pressure. This is a type of spraying that allows you to spray extremely accurately but without all the overspray that occurs with high pressure ...
Always keep the motor unit as far away from the spraying area as possible to prevent paint contaminating the motor. Mask off any area you do not wish to spray. Once you have set up and ready to spray, switch on the unit. No paint will be sprayed until the trigger on the spray gun is gently pulled. B...
1. Evenly control the speed of movement of the spray gun. A fast speed will give a thin coat and a slow speed will give a thick coat. 2. Only apply one coat at a time. If a further coat is required follow the paint manufacturer’s instructions for drying times. 3. If spraying small areas or objects k...
Remember to disconnect the unit from the mains power when undertaking any cleaning of the earlex sprayport ® . The spray gun must be thoroughly cleaned immediately after use. If the paint dries inside the gun, cleaning will become much more difficult and may render the gun inoperable. This is not co...
Spray gun ● keep the internal workings of the spray gun clean. The spray gun should be thoroughly cleaned after each use. Follow the cleaning instructions on page 8 with reference to the exploded parts view on page 3. ● check the needle and fluid tip on a regular basis for excessive wear, and replac...
The paint drips paint too diluted add undiluted material on item paint volume reduce the paint flow by turning fluid being painted too high adjusting screw (12) clockwise moving too slowly increase speed of application spray gun trigger release trigger earlier held too long spray gun too close incre...
11 spray gun design registration gb 3006933 copyright & design right reserved © 2012 guarantee this product is guaranteed for a period of 12 months for ordinary use and 6 months for hire purposes or where the unit is lent to other users.The guarantee is against faulty manufacture and materials. Whil...
© 2012 earlex ltd. N0151 11/12 earlex ltd, opus park, moorfield road, guildford, surrey, gu1 1sz, uk tel: +44 (0)1483 454666 email: enquires@earlex.Co.Uk website: www.Earlex.Com.
