Earlex SPRAY SYSTEM HV 1900 Operating Instructions Manual - Technical Specification
2
SAFETY OPERATING INSTRUCTIONS
PLEASE READ BEFORE USE
l
An airtight seal is essential for the correct operation of this gun.
l
Before operating the unit please ensure that the container is securely fixed
to the gun body and the gland nut (9) is not loose.
l
Over time the gland seal (10) will wear and need adjusting. To check the gland
nut is correctly fitted you will need a small adjustable spanner. Pull the
trigger back and gradually tighten the gland nut by turning it in a
clockwise direction until the needle is not free to move when the trigger is
released.
l
To obtain the optimum setting gradually unscrew the nut by turning it in an
anti-clockwise direction until the needle moves forward into the fluid tip (4).
To check your settings are correct spray a container of water. Re-adjust if
necessary.
l
NEVER under any circumstances aim the nozzle at another person or animal.
In the event of injury occurring seek expert medical advice immediately.
l
The spray gun must only be used with paints and solvents that have a
suitable flash point for spraying. If in doubt consult paint or solvent
manufacturer’s data.
l
Always ensure there is adequate ventilation when spraying.
l
NEVER spray near a naked flame, including appliance pilot flame.
l
NEVER smoke whilst spraying.
l
NEVER allow children to operate or play with the spray gun.
l
Always read the paint manufacturer’s thinning instructions before using.
l
Always disconnect unit from mains supply when refilling the paint container.
l
Before cleaning, always disconnect unit from the mains supply.
l
Always wear the correct protective face mask when spraying. We would also
recommend the use of gloves, goggles and overalls.
l
After every use ensure that you clean your spray gun thoroughly and grease
the gland packing.
l
Use only genuine manufacturer replacement parts.
WARNING: The substances used with this spray gun (paint, thinners etc) may
contain hazardous, harmful, explosive or corrosive materials. ALWAYS COMPLY
WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND THE
MATERIAL BEING USED.
Only use the unit as detailed in these instructions.
TECHNICAL SPECIFICATION
Volts
230V
Watts
400W
Airflow
970 ltr/min
Output Volume
400gr/min(MAX)(WATER)
Container Capacity
0.9ltr
Hose Length
2.70m