1. DL manuals
  2. Earth Stove
  3. Wood stove
  4. EARTHSTOVE 1500HT
  5. Installation And Operation Manual

Earth Stove EARTHSTOVE 1500HT Installation And Operation Manual

Manual is about: Milwaukee Stove User Manual

Summary of EARTHSTOVE 1500HT

  • Page 1

    Installation and operation manual retain these instructions for future reference this appliance must be installed by a qualified installer. Read entire manual thoroughly before installation. P p/n 775001m, rev. Q, 12/03 model 1500ht epa certified wood burning stove.

  • Page 2

    Important warnings caution: please read this entire manual before you install and use your new room heater. For your safety, follow the installation, operation and maintenance instruc- tions exactly, without deviation. Failure to follow these instructions may result in property damage, bodily injury...

  • Page 3

    Page 3 table of contents important warnings ................................................ 2 testing/listing, epa, using this manual.................. 3 planning your installation ..................................... 4-6 manufactured (mobile) home requirements ...........6 installation .............

  • Page 4

    Planning your installation page 4 questions to ask local building official a correct installation is critical and imperative for reduc- ing fire hazards and perilous conditions that can arise when wood burning appliances are improperly installed. The installer must follow all of the manufacturers’ i...

  • Page 5

    Planning your installation page 5 combustible wall clearance warning: it is very important that you observe the minimum clearances. There are listed clearances for your stove which were determined in a laboratory test using various "classes" of stove pipe or chimney. Minimums are first estab- lished...

  • Page 6

    Planning your installation page 6 reduced masonry structure clearance (alcove) your earth stove can be installed in a masonry struc- ture with reduced clearances if the structure was built to national building code for fireplaces and chimneys (ubc 37). The firebox of the masonry structure must be of...

  • Page 7

    Installation page 7 once the outside air floor duct is in position, replace the floor protector. Make sure that the floor protector's hole is aligned with the outside air opening. Next position and align the stove on the hearth pad. Manufactured (mobile) home installations require that the stove be ...

  • Page 8

    Installation page 8 installing the baffle bricks there are 2 brick retainer tube assemblies located be- low the ceiling of the firebox which require baffle brick before the stove can be operated. Install the baffle brick as follows: 1. Place the first three brick onto the brick retainers with the no...

  • Page 9

    Installation page 9 acceptable connector pipe for installa- tions for standard residential clearances: six 6 inch (152 mm) minimum, single wall, 25 gage minimum thickness, stove pipe is acceptable. Three (3) pre-drilled holes are provided in the flue collar for fastening the pipe securely to the sto...

  • Page 10

    Installation page 10 chimney height requirements the chimney must extend 3 feet (914 mm) above the level of roof penetration and a minimum of 2 feet (610 mm) higher than any roof surface within 10 feet (305 cm) (see below). Check with your local building officials for any additional requirements for...

  • Page 11

    Installation page 11 residential standard using 6” (152 mm) diameter single wall con- nector pipe not approved for manufactured (mobile) home manufactured (mobile) home standard using 6” (152 mm) diameter type l-vent connector pipe.

  • Page 12

    Installation combustible wall chimney connector pass-throughs notes: 1. Connectors to a masonry chimney, excepting method b, shall extend in one continuous section through the wall pass-through system and the chimney wall, to but not past the inner flue liner face. 2. A chimney connector shall not p...

  • Page 13

    Product features and controls care and operati0n page 13 ash drawer the large ash drawer located on the left side of the ped- estal is designed to make cleaning easier by containing the ashes in a removable drawer. Caution: do not operate the stove with the ash drawer open or ajar, as this will prod...

  • Page 14

    Care and operation page 14 primary air control this appliance is equipped with a control for the combustion air, located on the lower right side (front) of the stove. Slid- ing the control to the right increases the burn rate, to the left decreases the burn rate. You will generally want to set the c...

  • Page 15

    Fuel page 15 burn recommended fuel this appliance is approved for use with untreated natural dry wood only (see important warnings, page 2, #8). Do not burn particleboard scraps or pressed logs using bond- ing agents because they can produce conditions that will deteriorate metal. Green or uncured w...

  • Page 16

    Maintenance page 16 small area paint touch-up the stove body is painted with a quality high-temperature stove paint. Use only model tspk-b stove paint, catalog # 70k99. Do not touch-up your stove with any other paint. Using one small piece of 320 grit sand paper and lightly sand the blemish so that ...

  • Page 17

    Maintenance page 17 replacing glass: 1. Remove door from stove by lifting door up and off hinge pins: place the door on a flat protected (towel) clean flat surface with the inside of the door facing up. Remove the glass clips (by removing screws holding clips), then care- fully remove broken glass o...

  • Page 18

    Troubleshooting page 18 smokes out fuel door when open (see ✸) 1. The primary air control is closed. 2. The chimney is too cool. Set the primary air control on "high" for a few minutes before opening the fuel door. 3. Excess creosote will not only restrict your draft but it will create a risk of a c...

  • Page 19

    Troubleshooting page 19 the following are a few conditions that should be evaluated and (corrected if necessary) if an overfiring condition is sus- pected: overfiring caused from improper installation - ensure that all installation requirements have been met as outlined in the installation manual. T...

  • Page 20

    Specifications: model 1500 ht page 20 approximate heating capacity up to ~1500 sq. Ft. (up to ~450 sq. M) outside air provision yes log length 20" (508 mm) flue position top flue collar size 6" (152 mm) width 27 1/2" (699 mm) depth 24" (610 mm) height (to flue) 30 3/4" (781 mm) height 29 3/4" (756 m...

  • Page 21

    Replacement parts list - model 1500ht page 21 part no. Description door parts g6000 door assembly, cast black 14m72 door assembly, gold 27m67 clip set, glass 86-128 door gasket kit, 3/4" rope (includes adhesive) 27m81 gasket, glass channel (per foot) g2000-7 glass, arched 9 1/2 x 15 3/4" (glass gask...

  • Page 22

    Component diagrams – model 1500ht firebrick part/catalog # quantity dimensions part/catalog # quantity dimensions fb-1 6 9 x 4 1/2” fb11 1 4 1/2” x 4 3/8” fb2 10 9 x 4 1/2” w/notch 10545 5 * 9 x 4 1/2” w/notch 01115 1 grate fb-5 1 9 x 2 1/2” w/hole * baffle brick are a special denser brick. Do not s...

  • Page 23

    Optional accessories – model 1500ht note: install and use accessories per instructions provided with the accessory kit. Page 23 catalog # model # description notes 14m67 oafd-s outside air floor duct 5 1/4" square 14m72 dk100-g gold door kit 14m22 bk-100 blower kit includes dial-a- temp for variable...

  • Page 24

    Safety/listing label page 24.

  • Page 25

    Epa label page 25.

  • Page 26

    Page 26 ownership records dealer’s name: dealer’s address: city: state: zip code: serial number: date of purchase: date installed: notes: service and maintenance log service service service date technician description.

  • Page 27: 1110 West Taft Avenue

    1110 west taft avenue orange, ca 92865.